Drolo Stamme n Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Pedale musicale Drolo Stamme n. Drolo Stamme n 4.

WET/DRY : These pots are used to set the level for wet and dry. In the middle position they are about unity

gain, which means that you can also boost signals when the effect is engaged.

BYPASS switch: This is an electronic bypass, meaning that when bypassed, the signal goes through a buffer.

If tapped quickly, the switch will turn the effect on/off but if you hold it for more than 0.3 seconds while it

was off, the switch will engage the effect momentarily until you release the switch.

EXP input:

Can be used to externally control the ... control pot with an expression pedal. When an expression pedal is

plugged in, the control pot can be used to scale the range of the expression pedal.

Remove the power supply plug before connecting anything to the expression input.

Most commercially available expression pedals using a ¼ inch TRS (or stereo) plug should work. The value is

not really critical, although I would not go lower than 10k. (Ex:

TRS

You need to use

voltage regulator inside the pedal and damage it.

Here is how such a TRS plug looks like.

The exp jack is connected to the pedal like this:

sleeve: ground

ring:

3.3V supply voltage

tip:

control voltage

If you really know what you are doing you can actually use a control voltage instead of a resistance based

controller. But you need to consider the connections and never exceed 3.3V. If you do you will damage the

pedal. Just connect the sleeve and tip and leave the ring unconnected (not shorted so don't use mono

cables)

If you have any doubt when deciding what to connect to the expression input please send me an email and I

will verify that everything is safe.

Thanks :)

David

http://www.davidrolo.com

(stereo) plugs and cables.

Moog EP-2, Roland EV-5, and M-Audio EX-P)

NO MONO PLUGS OR CABLES!

These will short out the