247Security mDVR300 Series Manuale rapido - Pagina 7

Sfoglia online o scarica il pdf Manuale rapido per DVR 247Security mDVR300 Series. 247Security mDVR300 Series 14.

4. EQUIPMENT TEST

When all of the cameras, cables, and add-on modules have been installed and when the DVR is connected to your

on-site laptop, the completed setup needs to be tested. To begin the test, ensure the DVR's Hard Drive is inserted in

the DVR and the lock is turned to the locked position and then turn the vehicle's ignition to ACC or ON. Starting the

vehicle's engine—and, by extension, the alternator to charge the battery—during the test is not essential. Ensure that

you have direct line-of-sight to the front of the DVR to see the LED indicators.

Note: At the first sign of a hazard/malfunction (electrical fire, smoke) immediately turn the vehicle's ignition OFF.

The mDVR306 Series DVR normal boot sequence is as follows:

Time Elapsed

Sequence

[minutes : seconds]

0:05

0:15

0:20

0:45

0:50

1:00

247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com

The IGN (ignition) indicator will turn on. The DVR is idling in Stand-By

mode. It is not online or recording.

The PWR (power) indicator will turn on while the IGN (ignition) indicator

will flash, repeatedly. The DVR is now undergoing its boot sequence.

The green POWER indicator on the Event Marker will turn on. The DVR

cooling fan (four channel DVR's) will turn on.

The IGN (ignition) and PWR (power) indicators will turn on solid. The DVR

has completed its boot sequence.

The record light on the front of the DVR will come on.

The amber RECORD light on the Event Marker will turn on solid, also

indicating that the hard drive is recording data. The DVR is now ready to

record, or to be serviced through the Ethernet Cable from your laptop.

NOTE: ON THE mDVR306 SERIES DVR'S WHEN THE X-CROSS CABLE IS

CONNECTED TO THE DVR FOR CONFIGURING THE BUS AND AIMING

CAMERAS, THE UNIT WILL NOT RECORD, AS SOON AS YOU DISCONNECT

THE X-CROSS CABLE FROM THE DVR WITH-IN 10 SECONDS THE DVR WILL

AGAIN BEGIN RECORDING. THIS CAN BE CHANGED IN THE SET-UP OF THE

DVR IN THE SYSTEM TAB.

QUICK GUIDE

mDVR306 Installation

Activity