Drop SC-48 Manuale di installazione - Pagina 3

Sfoglia online o scarica il pdf Manuale di installazione per Distributore d'acqua Drop SC-48. Drop SC-48 20.

Introduction................................................................................................... 2

Table of Contents.........................................................................................

How to Use Soft Water...............................................................................

How to Use Your System..........................................................................

System Operation Modes..........................................................................

Additional Features...................................................................................

System Maintenance and Adjustments....................................................

Installation Instructions.............................................................................

Contents of Carton....................................................................................

Precautions...............................................................................................

System Set Up............................................................................................... 10

System Start Up......................................................................................... 15

Common Questions...................................................................................

CAUTION:

• Do not subject tank to any vacuum. If there is a possibility that a vacuum could occur, a vacuum breaker must be installed.

• Do not locate unit where the tank or any lines (including drain lines) will be subject to temperatures below freezing.

• If there is not at least 10' of line between the water heater inlet and the outlet of the closest softener/filter, an expansion tank

should be installed.

• Do not use Vaseline or any petroleum-based lubricants on O-rings or rubber seals. Only use food-grade silicone lubricant.

• O-rings are lubricated before leaving the factory and do not require additional lubrication before installation in most cases.

• Do not use pipe dope or any sealant other than Teflon tape on threaded connections. Threads on the control valve and on the

bypass nut connections do not require any tape because they use an O-ring seal. Tape is only required on the inlet/outlet

adapter fittings and on the drain line fitting (if applicable).

Your Water Test Results

Hardness ________________

Iron ____________________

pH _____________________

Chlorine _________________

gpg

ppm

number

ppm

TABLE OF CONTENTS