ANLIDAR MYTORQ MYAC51-1512LF Manuale di funzionamento e manutenzione - Pagina 7
Sfoglia online o scarica il pdf Manuale di funzionamento e manutenzione per Cacciavite elettrico ANLIDAR MYTORQ MYAC51-1512LF. ANLIDAR MYTORQ MYAC51-1512LF 11.
Stampa la pagina(1). Forward/Reverse Switch : To switch screwdriver run in Reserve or Forward
R : Run in reserve to untighten screw。
F : Run in Froward to tighten screw。
(2). L-TYPE: Press Level switch and hold to start screwdriver, release to stop。
P-TYPE: Under Pressure and hold to start screwdriver, release to stop。
(3). Front Locking Ring : To fixed the housing of screwdriver。
(4). Torque Adjusting Ring : To adjust torque from low (scale 0) to high (scale 8) torque。
(5). Bit holder cap : Pull out to put bit into the holder or take out from the holder。
Attaching / detaching bit and bit type
Push up the holder clamp by finger tip, and it will be unlocked. Thus, the bit can be freely attached and detached (single finger
notion type) select such a bit whose shank is equal to the size shown below.
Insert the power plug into a receptacle and set the changeover switch to "F" position.
Apply the bit to the screw head and press the lever or push main body to, then the switch will be turned ON to start the motor
running.
When the screw is tighten and reach the torque that you had set, The tool will stopped automatically.
To reset the tool by releasing the lever to the original position or releasing the bit From the screw head.
To return the screw, set the changeover switch to "R" position.
Function Discription
(2)
L-TYPE
(3)
(5)
Description of Operation
(1)
P-TYPE
(3)
(4)
(5)
6
(1)
Under Pressure
(2)
(4)