ANLIDAR MYTORQ MYAC52-0317LF Manuale di funzionamento e manutenzione - Pagina 6

Sfoglia online o scarica il pdf Manuale di funzionamento e manutenzione per Cacciavite elettrico ANLIDAR MYTORQ MYAC52-0317LF. ANLIDAR MYTORQ MYAC52-0317LF 11.

Stampa la pagina

1) Whenever changing a bit, make certain the Forward / Reverse Switch is in the " OFF " position and tool is unplugged.

2) To avoid damaging the housing of screwdriver, do not allow chemicals get in touch with housing of screwdriver. Ex.: Acetone,

benzene, thinner, trichloroethylene ketone, and other similar chemicals.

3) Use screwdriver carefully, do not drop or abuse. It would be better to use with the spring balancer. If without spring balancer,

you can place the screwdriver in the suspension rack.

4) Assemble / disassemble bits : Only use fingers pull up the bit sleeve to release bits. ; Place back the bit sleeve to lock the bit

holder.

Attention : Make sure the power is off, or the Forward / Reverse switch stays at "OFF" position when assemble or disassemble

bits.

5) Connect the plug to the socket. Attention : It will cause an electric shock if the plug or the hand is wet.

6) You can adjust the torque by the torque adjusting ring. The number on the scale is not equal to the real torque, please refer to our

torque range chart, or test the torque by our torque meter.

Attention : Do not adjust the torque setting higher than 8 on the torque scale.

7) MYAC52-1512 Series screwdriver : When fasten a screw, please point the bit to left, move down the Forward / Reverse

switch to the bottom. (If the screw is reversed-thread screw, move up the Forward / Reverse switch to the top.)

Point at the place of the bit and the screw, press the trigger to start; Whentorque reaches user's setting, the clutch will shut out

automatically, the power will shut off and the motor breaks immediately, the screwdriver stop running.

8) Trigger Start Type screwdriver : When loosen a fastened screw, please set Forward / Reverse switch to "Reverse".

(If the screw is reversed-thread screw, please set Forward / Reverse switch to "Forward".)

Follow the above operation, after loosening the screw, release the trigger to stop.

Push Start Type screwdriver : When loosen a fastened screw, please set Forward / Reverse switch to "Reverse"

(If the screw is reversed-thread screw, please set Forward / Reverse switch to "Forward".)

Follow the above operation, after loosening the screw, stop pushing the screwdriver to stop.

9) Operation frequency: The original setting of the frequency is 1 sec on / 3 sec off. The number of screw fastened is about 15 pcs.

Over frequently using makes the motor overheated and damage to screwdriver.

Enough heat-dissipation is good for screwdriver.

10) Do not use this screwdriver to fasten wooden screws.

11) Do not operate the Forward / Reverse switch when the motor is running.

12) Whenever a screwdriver is not being used, move the Forward / Reverse switch to the "middle" position and unplug the

screwdriver.

13) Keep staying aware.

Pay attention on your work, check safety measures and every part is workable before using screwdrivers, to make

sure screwdrivers can work under original design function.

● Do not drop or abuse the tool.

● Whenever a tool is not being used, position the Power Switch to the "OFF" position and unplug the power cord.

Operations Cautions

CAUTION