ANLIDAR MYTORQ MYBT-EP0612 Manuale di funzionamento e manutenzione - Pagina 17
Sfoglia online o scarica il pdf Manuale di funzionamento e manutenzione per Cacciavite elettrico ANLIDAR MYTORQ MYBT-EP0612. ANLIDAR MYTORQ MYBT-EP0612 19. Automatic industrial cordless brushless power torque screwdrivers series
Stampa la pagina1.
The best condition of using the tool is under 8 hours a day, do not over loaded.
2.
Do not attempt to repair or disassemble this cordless screwdriver without authorization.
Always have the device serviced by assigned factory or qualified person in order to have the
warranty effective continually.
3.
Anlidar is not responsible for any poor performance or damage caused by customers own
modification of the tool.
4.
It is necessary for the management to have individual operators read and follow up all
instructions in this manual. Do not attempt to repair or disassemble this cordless screwdriver
themselves.
5.
Chemicals, Acetone, Benzene, Alcohol, Thinner, Ketone, trichloroethylene, etc shall not be in
contact with the surface of the screwdriver in order to prevent chemical damage.
6.
Please follow instruction carefully and do not drop or shock the screwdriver.
7.
This is an external torque adjustment screwdriver, 0 on the torque adjust ring stands for
minimum torque and 8 for maximum torque. The rated operation time is 1 second / 3 seconds
(ON / OFF). Appropriate fastening frequency is 15 fasteners in each minute. Overrunning may
damage motor due to overheat. Proper amount of screwdriver resting is recommended to
prevent motor overheating.
8.
Not allow to turn the Hi/Lo switch during operation in order to cause system maltfunction.
9.
The device will not be able to function again once the OK/NG indicator/signal is not turn off
yet.
10. When adjusting the torque, for safety purpose should stop the screwdriver completely and set
the switch to neutral position. It could prevent the user from turning the tool on accidentally.
11. During operation, the switch has been changed accidentally that the device will enable its
self-protecting mode which is power off. Re-start the tool when this happen.
12. Each operational torque setting, using time and frequency may result in different level of wear
and tear, at higher torque setting and use extensively could accelerate the wearing down of tool.
After one month, the torque is getting reduction gradually at the rate of 2~3% or 3~5 %( max
torque). The longer use of the device, torque reduction will become stable and the users could
measure the torque by a tester on a regular time schedule to check if the torque power still
meets the criteria.
13. MYBT-EP series cordless screwdriver are tested by our torque meter KTM-150.
14. Anlidar cordless screwdriver torque output is generated by clutch mechanism, and it is
applicable to ISO 6789.
Description of Battery and Charger
1. KILEWS SKC-LB1820B series of batteries as options to fit in the device; you may consult with
local agent based on your task requirement.
2. The use of other than genuine KILEWS batteries or screwdrivers can't be active due to the
build-in protection system enforce no charging.
3. Recommended to use MYCS-ID80-D
Other Cautions
16