Drytac HOT PRESS HGP360 Manuale d'uso - Pagina 3
Sfoglia online o scarica il pdf Manuale d'uso per Utensile elettrico Drytac HOT PRESS HGP360. Drytac HOT PRESS HGP360 19. Heated glass top vacuum press
Anche per Drytac HOT PRESS HGP360: Manuale dell'operatore (19 pagine)
Stampa la pagina
HOT PRESS USERS MANUAL
Safety Considerations
This product should only be used for the purpose and manner for
which it was designed. Before installing and using the equipment,
please read this entire manual and be sure that you understand
all the aspects of proper use. Some of the more important safety
considerations are listed below.
• Ideally, the vacuum press should be used with a metal stand
(available from Drytac). If a stand is not used, the press
must be located on a sturdy table or countertop capable of
supporting its weight (refer to Technical Specifi cations on page
17 of this manual). The largest model (HGP560) is supplied
with a stand, which must be used due to the weight of the unit.
• Connection of the equipment to the power source must be
handled by a qualifi ed electrician familiar with local and
national electrical codes. It is mandatory that the equipment be
properly grounded.
• The gas struts which support the lid are a critical safety item.
They must be fully extended (in other words, the lid must be
open completely) in order for them to support the weight of the
lid. The press must be installed in a location which allows the
lid to be completely raised without interference. If the lid is only
partially opened, it may close unexpectedly.
• Before each use, the struts should be checked to be sure they
are operating properly. Over a period of time, the struts will
lose pressure and will eventually require replacement.
• The inner surface of the glass top is very hot during normal
operation. Be very careful not to touch the glass when
inserting or removing materials from the press.
• Before servicing the equipment, it must be disconnected from
the power source.
• If either of the circuit breakers on the rear panel of the unit
should trip repeatedly, unplug the equipment and have it
serviced. The same applies to the fuses on the side panel.
• The vacuum press incorporates a high-temperature safety
cutout device, which disconnects all power from the unit if the
internal temperature reaches a predetermined level (257°F
/ 125°C). If the unit unexpectedly shuts off during use and
later comes back on after cooling down, it is likely that this
safety device has activated. This indicates a problem with the
temperature control system, and the unit should be repaired by
a qualifi ed technician.
• Do not use a knife to cut materials while they are inside the
press. This could cause damage to the diaphragm.
3
Safety