Drytac HOT PRESS HGP360 Manuale dell'operatore - Pagina 8
Sfoglia online o scarica il pdf Manuale dell'operatore per Utensile elettrico Drytac HOT PRESS HGP360. Drytac HOT PRESS HGP360 19. Heated glass top vacuum press
Anche per Drytac HOT PRESS HGP360: Manuale d'uso (19 pagine)
Stampa la pagina
two stages of resistance as the tube is inserted. The ends of the tubing must be clean and smooth
to ensure a good seal. If damaged, simply cut off 1/4" (5mm) with a sharp knife. To remove the
tubing, press the end of the metal fitting and pull the tubing out.
Plug the electrical cord from the pump into the matching connector on the rear of the vacuum
press.
All four models of the Drytac Glass Top Vacuum Press require single-phase AC power. The
current and power requirements are different for each model, and are summarized below.
Electrical Specifications
Model
220-240 VAC
Voltage
Current
Current
((peak)
Power
Circuit
Please be sure to provide adequate ventilation if the equipment is to be used in a high-volume
production environment.
Make certain that the power source conforms to the requirements specified above. All local
electrical and safety codes, as well as the current National Electrical Code (NEC) must be
followed. All wiring must be installed by a qualified electrician.
To reduce the risk of electrical shock, the vacuum press must be used only with a properly
installed 3-wire grounding-type receptacle and plug combination. Do not use extension cords or 2-
prong adapters with this equipment. Proper grounding of the receptacle must be verified before
use.
The electrical cord should be routed and secured so that it does not present a hazard. Protect the
cord at all times from sharp objects, hot surfaces, oil and chemicals. Avoid kinking the cord.
Periodically inspect the cord and plug, and replace immediately if worn or damaged.
Disconnect the equipment from the power source before moving or servicing.
PRESSURE ADJUSTMENT KNOB: Adjusts pressure for applications such as mounting onto
foam boards.
HGP-220
220-240 VAC
50/60Hz
10A
11A
2.3 KW
20A
Illustration 7A: Main Controls
HGP-260
220-240 VAC
50/60Hz
11A
13A
2.5KW
20A
HGP-360
HGP-560
220-240 VAC
50/60Hz
50/60Hz
18A
22A
4.2KW
30A
25A
28A
6.7KW
40A
8