Anova TP3002 Manuale d'uso/istruzioni - Pagina 6

Sfoglia online o scarica il pdf Manuale d'uso/istruzioni per Utensile elettrico Anova TP3002. Anova TP3002 11. Battery pruning shears

3. Use and maintenance

1. Remove the machine from the packaging. Install the lithium battery, press and hold the power switch

for three seconds, and then release it. You should hear the sound of two beeps; this means that the

battery is normally charged.

2. Press the trigger continuously and quickly twice to open the blade automatically.

3. Before starting work, press the trigger to operate the blade several times and listen for unusual noises

or working speed that is too fast or too slow. If everything is normal, you can start working.

4. Shutdown: Press the trigger and release after you hear a beep three times. The blade will close

automatically.

Note:(1) The machine may overheat after a long time of use, this is a normal phenomenon. Let the

machine cool down for a while, and you can use it again when the temperature drops.

(2) After completing the pruning work, at the end of the season, or when replacing the blade, and need to

remove the blade, please add lubricating oil for the maintenance of the blade and cutting system.

While pruning, start pruning about 8mm from the shoot; the maximum cutting diameter is

30mm.

Prune at the furthest part of the shoot to prevent sap loss from the plant.

Do not prune branches too far down the tree, as this will reduce the health of the plant.

Leave a small section of the branch to avoid stress to the plant.

While you are working with the scissors, keep your hands away from the cutting blades

and wear suitable gloves and protective equipment.

Remove diseased shoots and remove dead branches on the plant.

When pruning a tree, prune each branch separately and do not cut multiple branches at

once.

The battery of a new machine is not fully charged. Before charging,

insert the battery into the charger and insert the charger plug into the power

outlet. As shown in the image on the right, the red indicator light shows that

the battery is charging; the green indicator light indicates that the battery is

charged. Use the scissor after full battery charges.

1. Before charging, please turn off the switch; During charging, it is normal to have a slightly warm

charger and batteries.

2. If the batteries are not used for a long time, they need to be recharged every 3 months to increase the

service life;

3. New batteries or batteries not used for a long time will reach full capacity after 5 times of charge-

discharge cycles;

4. Do not charge the batteries repeatedly after several minutes of operation, this may reduce the working

time and the effectiveness of the batteries.