DS18 CANDY-X48 Manuale d'uso - Pagina 14

Sfoglia online o scarica il pdf Manuale d'uso per Subwoofer DS18 CANDY-X48. DS18 CANDY-X48 16. Monoblock subwoofer / stereo full range class d amplifiers
Anche per DS18 CANDY-X48: Manuale d'uso (16 pagine)

Stampa la pagina

owner's manual

TROUBLESHOOTING

Before removing your amplifier, refer to the list below and follow the suggested

procedures. Always test the speakers and their wires first.

AMPLIFIER WILL NOT POWER UP.

Check for good ground connection.

Check that remote DC terminal has at least 10V DC.

Check that there is battery power on the + terminal.

Check all FUSES.

Check that protection LED is not lit. if it is lit, shut off amplifier briefly and then repower it.

HIGH HISS OR ENGINE NOISE (ALTERNATOR WHINE) IN SPEAKERS.

Disconnect all RCA inputs to the amplifier, if hiss/noise disappears, then plug in the

component driving the amplifier and unplug its inputs. If hiss/noise disappears, go on

until the faulty/noisy component is found. It is best to set the amplifier input level as

insensitive as possible. The best subjective S/N ratio ia obtainable this way. Try to drive

as high a signal level from the head unit as possible.

PROTECTION LED COMES ON WHEN THE AMPLIFIER IS POWERED UP.

Check for shorts on speaker leads.

Check that volume control on the head unit is turned down low.

Remove speaker leads, and reset the amplifier. If the protection LED still comes on, then

the amplifier is faulty.

The amplifier will shut down automatically when the units temperature goes up to 85

This will protect the units from damage.

AMPLIFIER GETS VERY HOT.

Check that the minimum speaker impedance for that model is correct.

Check for speaker shorts.

Check that there is good airflow around the amplifier. In some applications, an external

cooling fan may be required.

DISTORTED SOUND.

Check that the level control is set to match the singal level of the head unit.

Check that all crossover frequencies have been properly set.

Check for shorts on the speaker leads.

HIGH SQUEAL NOISE FROM SPEAKERS.

This is always caused by poorly grounded RCA patch cord.

WARNING

1. Over high volume will damage your speakers.

2. Be cautious when you use the amplifier near gasolike tank and electric wires.

3. Protect the connecting wires and parts to avoid any damage or short circuit.

4. The power must belee from the anode of the battery via FUSE.

5. The sound system must be in turning-off situation when you check the amplifier.

6. Be sure that you use the same type of FUSE when you need to replace it.

* We reserve the right to make needed change or improvement to the product, without

informing the customer about this in advance.