DSC Envoy NT9010 Manuale d'uso - Pagina 10

Sfoglia online o scarica il pdf Manuale d'uso per Sistema di sicurezza DSC Envoy NT9010. DSC Envoy NT9010 20. Demo stand
Anche per DSC Envoy NT9010: Istruzioni per l'installazione (4 pagine)

Stampa la pagina

Section 2: Using Your NT9010 System

Operating the

The NT9010 controller provides easy to understand voice prompts to help you to

System from

use your system.

the NT9010

You can check the current status of your system by pressing the Status button. The

controller

NT9010 will announce the time, whether the system is currently on (armed) or off

(disarmed), if any zones are currently open or bypassed (turned off), and if there

are any trouble conditions currently present on the system. Pressing the Status

button while the NT9010 is speaking will cause it to stop.

Operating the

If your installer has connected your NT9010 system to an incoming telephone line,

System from

you can access the system using a local telephone (a telephone on your premise).

a Telephone

You may also be able to use the system from a remote telephone (a telephone not

on your premise), if your installer has turned on this feature.

Even though you can use a telephone to operate your system, the telephone can

not display or indicate system status or zones in alarm. Therefore, it is essential

that you check the NT9010 controller regularly for any changes in system status.

CAUTION: For the security of your codes, DO NOT use a telephone with a

redial button to arm or disarm your system.

NOTE: The Duress Code should only be used from the local controller and

not from a local or a remote telephone.

Local Telephone Access

Use this procedure to call your NT9010 system within your home from a telephone

that is on the same telephone line. No dial-in is necessary.

1. Pick up the telephone handset - you will hear a dial tone.

2. Enter your 3-digit Telephone Access Code. The dial tone will stop and the sys-

tem will announce:

"Hello."

3. The system may also say:

"Enter your access code."

If so, enter your [access code].

4. The system announces one or more messages to advise you of its status. Follow

the voice prompts to use the system functions.

Door/Window

WLS925L-433

To remove the cover of the universal trans-

Contacts

mitter, squeeze both sides of the unit where

the notches are. Pull to release the cover.

Use care when installing the battery and

observe the correct polarity (see diagram).

Use only an Eveready Lithium Energizer No.

EL123AP battery.

Motion

WLS904-433/WLS904P-433

Remove the motion detector from its mounting plate by

Detectors

holding the detector by its sides and pushing up.

Remove the old batteries and install four fresh Eveready

Alkaline Energizer AAA batteries. Be sure to observe cor-

rect polarity when inserting the batteries. Replace the

detector on its mounting plate, making sure it snaps into

place.

WLS914-433

Remove the motion detector from its mounting plate by holding the

sensor by its sides and pushing up. Install four fresh Eveready Alka-

line Energizer AA batteries. Be sure to insert the batteries in the

proper orientation. Replace the sensor on its mounting plate, making

sure it snaps into place. After the batteries are installed, the detector

will take 60 seconds to warm up. During this time the LED will flash.

Glassbreak

WLS912-433

Detectors

Remove the detector from its mounting plate by

pushing the detector in the direction shown at

right.

Install the three Eveready Alkaline Energizer bat-

teries, with the correct polarity, as shown at

right.

R ep la ci ng Ba t t e r ie s