DSE DSE2157 Manuale di istruzioni per l'installazione

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Unità di controllo DSE DSE2157. DSE DSE2157 15.

053-034

ISSUE 2

Introduction

DSE2157 relay expansion module is used in conjunction with the DSE7000 series controllers to

provide additional relay output functionality. The relay outputs are configured in the 'host controller',

the DSE2157 module is not itself configured apart from the 'ID switch' detailed below.

For further details on configuring the 'host controller' you are referred to the relevant configuration

software manual.

Controls and indications

Power on /

Link lost LED

LED Indications

Function

Power on / Link lost

Status 1-8

ID switch

The rotary ID switch is used to select the 'ID' of the 2157 expansion module as the host controller is

capable of giving instructions to a number of 2157 expansion modules at the same time (consult

relevant modules instructions for further details on number of supported expansion units).

The enclosure cover must be unclipped and removed to gain access to the switch. The switch should

be operated using a small screwdriver and set to match the required ID.

NOTE : The ID must be a unique number, different from the ID of any other 2157 module

connected to the host controller.

If two or more 2157 controllers are required to 'mimic' each other then they should be

configured with different IDs, and both configured the same in the host controller.

NOTE : The selection of the ID of other types of expansion modules WILL NOT interfere/clash

with the ID of the 2548. For instance if the 2548 is set to ID 4, it is acceptable to have a different

type of expansion module (for instance 2130) set to ID 4 also.

D E E P S E A E L E C T R O N I C S

2157 Output Expansion Installation Instructions

Colour

Action

RED

Steady when DC supply is connected and data is being received

from the host controller.

Flashing when the DC supply is connected and the data

connection to the host controller is not operating.

RED

Lit when the corresponding relay is active

ID Switch

8 x Status LED

(1 LED per

relay)