ATS Diesel Performance Aurora Plus - 5000 Manuale di installazione - Pagina 4
Sfoglia online o scarica il pdf Manuale di installazione per Automobile Accessories ATS Diesel Performance Aurora Plus - 5000. ATS Diesel Performance Aurora Plus - 5000 18. Aurora plus - 5000 turbo kit (2003-2007) 5.9l dodge
Stampa la paginacontrol solenoid from the engine harness and remove it from the stock
turbo. Install the harness jumper provided (Figure 2, #13) in the kit to
prevent the computer from setting the check engine light.
Harness Jumper
6. Remove the rubber grommet from the factory front air box and install it
into the ATS air box mounting bracket. If the grommet cannot be found, a
large flat washer will work.
7. Remove the factory turbo-to-intercooler charge pipe.
8. Remove the rubber hump boot on the intercooler inlet.
9. Disconnect the factory oil feed line from the top of the factory turbo and
disconnect the oil drain from the bottom of the factory turbo. Retain the
bolts.
10. Disconnect the exhaust by removing the v-band clamp that holds the
exhaust elbow to the turbine housing. There are two locating pins that will
either be stuck in the exhaust elbow or turbo outlet flange; remove and
discard both pins.
11. Remove the four nuts securing the heat shield to the manifold.
12. Cut and remove the bracket securing heater hose to the manifold stud.
Be sure not to cut the heater hose.
13. Using a pair of side cutters, remove the safety straps from the back four
manifold bolts.
14. With the factory turbo still in place, remove the 12 manifold bolts to
remove the stock turbo and manifold as one piece. Place the assembly
on a workbench or equivalent sturdy work surface.
15. With the turbo/manifold assembly on the workbench, remove the four nuts
securing manifold to turbo flange and separate the turbo and manifold.
The four nuts can be very difficult to loosen. Use penetrating oil on stud
threads before attempting to loosen nuts.
Wastegate Control
Solenoid