DSP AD1200 Istruzioni - Pagina 10

Sfoglia online o scarica il pdf Istruzioni per Telefono DSP AD1200. DSP AD1200 12.

3.00 User Mode / User Programming

Programming can only be done, when the unit is in off mode. This is indicated by the PWR LED

extinguished .

The dialer will exit user programming if no data entering after 2 minutes

3.01 Enter User Programming

To enter off mode, enter in the valid User Code.

Press:

If the PWR LED is on after entering user code, re-enter the user code again.

Acceptance of programming is given by 6 short beeps from the buzzer., error tone is indicted by a

long beep.

3.02 Changing User Code

It is recommended that you change the user code from the factory default setting.

To Change user code:

Enter user code:

ot on LED display starts blinking, you are now in user programming mode.

Enter new 4 digit code:

3.03 Changing Telephone No.1

For security reasons it is only possible to change the 1

The telephone number entered should not be longer than 24 digits.

Enter user code:

Enter new telephone number Press:

3.04 Display Telephone No.1

Enter user code:

Enter user code:

If an Entry Exit Time was programmed the Exit Timer will be activated and the system will signal

the user with beeps to leave the premises.

AD1200 Installer Manual, Rev. 19.06.2013

Press: ENTER

Press:

ENTER

Press:

PWR LED extinguished.

CODE

telephone number in user programming.

PROG

READ

PROG

ENTER