DSPeaker Anti-Mode 8033Cinema Manuale d'uso - Pagina 4

Sfoglia online o scarica il pdf Manuale d'uso per Equalizzatore stereo DSPeaker Anti-Mode 8033Cinema. DSPeaker Anti-Mode 8033Cinema 12.

Stampa la pagina
ANTI-MODE 8033 User's Manual

1. Connections and Buttons

Figure 1: ANTI-MODE 8033 Front panel

1.1. Front panel:

1. Microphone input jack.
2. LIFT Button: LIFT25 / LIFT35 / FLAT selector.
Short press: Selects low frequency boost mode.
•
Long press (with bypass off): Stores current settings.
•
Long press (with bypass on): Enter filter selection mode (Anti-Mode 8033S-II).
•
3. BYPASS Button: BYPASS selector.
Short press: Toggle Bypass mode (disable / enable processing)
•
Long press: Begin secondary calibration for Wide Area Correction.
•
Long press of both LIFT and BYPASS buttons: Begin main calibration.
4. PWR LED: Lit when the device is on.
flashes in filter edit mode, other LEDs show selected filter (Anti-Mode 8033S-II).
•
5. BYPASS LED: Lit when the Anti-Mode correction and lifts are bypassed.
flickers for 3dB input level warning (if flickers constantly, please reduce input level)
•
6. LIFT25 LED: Lit when the 15-25Hz lifting EQ (equalization) and subsonic filter is on.
is dimly lit along with the LIFT35 LED when the subsonic filter is active without lift.
•
flashes during calibration.
•
flickers for output saturation warning (please reduce input level).
•
7. LIFT35 LED: Lit when the 25-35Hz lifting EQ and subsonic filter is on.
is dimly lit along with the LIFT25 LED when the subsonic filter is active without lift.
•
flickers for input overdrive warning (please reduce input level).
•

1.2. Back Panel

Figure 2: ANTI-MODE 8033Cinema rear panel
1. 9 VAC / 12 VDC connector: Input power.
2. LINE OUT / RCA connector: To subwoofer
3. LINE IN / RCA connector: LFE (Low-Frequency-Effects) or SUB (subwoofer) signal
from the pre-amplifier or AVR (Audio/Video Receiver).
Rev. 1.9
A
-M
NTI
ODE
2012-03-20
8033C
INEMA
Page 4 (12)