Attero Tech CommandHub Manuale d'uso - Pagina 16

Sfoglia online o scarica il pdf Manuale d'uso per Hardware di rete Attero Tech CommandHub. Attero Tech CommandHub 20. Unify proxy device for control and routing

Stampa la pagina

4.2.7 – Configure Network State Status

Timer Mode:

This command is used to configure the asynchronous notification of the Dante network state. The command is used to

enable/disable the asynchronous notifications, and the time interval in ms at which those notifications will be sent.

Immediate Mode:

Added additional functionality, the asynchronous notifications in addition to being controlled by a timer can now be

configured to be sent similar to an interrupt. Each and every Dante notification that occurs will be sent immediately and

only the one time when configured in this mode.

*Note: By default the asynchronous notifications are disabled upon initial configuration of the CommandHub

and must be enabled via the CSTS command if desired. In addition, the asynchronous messages will be sent out

continuously (if enabled) at the rate of the configured time interval until cleared by issuing the "GNST" command.

Disabling the asynchronous notifications require that both parameters be sent.

Start

Character

(Hex)

0x02

Parameter Values:

Enable Flag:

•

"0" – Disable Notifications

•

"1" – Enable Notifications

Time Interval:

•

Time in milliseconds.

*Note: Enabling the asynchronous with a time interval set to 0 will configure the notifications in the

immediate mode.

Example: "configure asynchronous notification" - enabling at 250ms notify rate.

Example: "configure immediate mode asynchronous notification" - enabling.

Example response: (The return value is always 0000 and is used as an "ACK" to the CSTS command)

Command

Enable Flag

(ASCII)

(ASCII) + <CR>

"CSTS"

"1" <CR>

Table 13 - CSTS Command Format

Time Interval

(ms)

(ASCII) + <CR>

"500" <CR>

Page 15

CommandHub

User Manual

Stop

Characters

0x03 0x07 0x04

614-00019-01