ATTI Shadow Tracker Micro Vision Istruzioni per l'installazione

Sfoglia online o scarica il pdf Istruzioni per l'installazione per GPS ATTI Shadow Tracker Micro Vision. ATTI Shadow Tracker Micro Vision 3.

Shadow Tracker Micro Vision Installation Instructions

Introduction

The Shadow Tracker Micro Vision system is a state of the art GPS vehicle Tracking

system. Combining Department of Defense global positioning system (GPS) information

with terrestrial based communication, The Shadow Tracker Vision gives users

unparalleled insight into their vehicles operations.

Connecting Power

The Tracking Unit must remain connected to a continuous power supply during vehicle

movement for accurate GPS collection and storage. The battery on the vehicle serves as

the power source for the Tracking Unit.

Power Connections

Red Lead: Connect to continuous 12-volt power source.

Black Lead: Connect to ground.

Blue Lead: Connect to 12-volt power source that is hot only

when ignition is on in the vehicle. This is only a sensor for

vehicle ignition activity

IMPORTANT: If a Unit is left on for an extended period in which the vehicle is not

running, the Unit may drain the vehicle battery to the point that the vehicle cannot be

started.

Mounting and Placement

Tracking Units are not weatherproof and are to be mounted inside the vehicle's passenger

compartment. The recommended placement location is under the dashboard or in the

glove compartment, but the Unit may be placed anywhere inside the vehicle's passenger

compartment, as long as it is kept out of direct sunlight and excessive moisture.

GPS Antenna Placement

The GPS Antenna requires an unobstructed view of the sky to obtain GPS satellite

acquisition; therefore, antenna placement is critical to achieve consistent performance.

The GPS Antenna supplied with your Tracking Unit is equipped with a magnetic mount.

You may choose to mount the antenna out of sight. Keep in mind that the antenna will

obtain a stronger, less disrupted signal if it is mounted under plastic or glass rather than

covered by metal.

While external mounting is optimal, the options below

historical have been the best locations to install if you do not

want the drivers to know the location of the antennas.

Under the windshield defrost vents.

Between dashboard and instrument cluster.