Attic Breeze 254A Manuale di installazione - Pagina 4

Sfoglia online o scarica il pdf Manuale di installazione per Ventilatore Attic Breeze 254A. Attic Breeze 254A 4. Curb-mounted attic fan

Installation Instructions (continued)

Step 10 - Mounting the Solar Panel: If installing Attic Breeze models AB-203A/204A/253A-

254A, skip ahead to Step 12. Depending on the mounting bracket option you have chosen

for your remotely mounted solar panel, you will need to either drill a hole in your roof or attic

wall to accommodate the solar panel wire. Using a power drill equipped with a ½ inch bit, drill

a hole in the roof centered over the area chosen for your solar panel or in the attic wall near

your adjustable bracket. Insert the solar panel wiring through the hole and into the attic.

Using the caulking gun, seal around the hole and wire. Continue installation of the solar

panel as directed by the instructions included with your specific mounting bracket kit.

MAKE SURE THE SOLAR PANEL IS INSTALLED WITHIN 14 LINEAR FEET OF THE

ATTIC VENT UNIT TO ALLOW FOR TENSION IN THE SOLAR PANEL WIRE. The solar

panel wire should have enough slack so that there is no tension on the connection to the attic

vent unit.

Step 11 - Securing the Solar Panel Wire: Find the solar panel wire that was fed into the

attic in Step 10 and temporarily secure it to the side of the attic hole. You may need to enter

the attic to retrieve the wire. Place the attic vent unit close to the curb box, near the secured

solar panel wire. Plug the attic vent wire connections into the solar panel wire and secure the

connection with electrical tape. Allow the connected wires to hang freely into the attic.

Step 12 - Installing the Attic Vent: Run a bead of caulking all around the top of the curb

box. Position the attic vent unit over the curb box so that the thermal switch wire (if included)

is hanging from the bottom side of the vent housing. Slide the attic vent over the curb box,

making sure that the vent housing is completely seated on the curb box and caulking sealant.

Step 13 - Securing the Attic Vent: Using self-tapping roofing screws, secure the attic vent

unit to the curb box. Attic Breeze recommends using at least two screws on each side of the

curb box to properly secure the unit. Replace any remaining tiles, shingles, or metal roofing

around the attic vent needed to complete the installation.

Step 14 - Weatherproofing: Using the caulking gun, caulk over all exposed screw heads on

the curb box. If installing Attic Breeze models AB-203D/204D/253D/254D, caulk over the

solar panel mounting bracket screws as required.

Congratulations, your installation is now complete! Make sure to save your warranty information and

invoice. If you have any questions or comments about our products, please contact our support staff

to discuss. From everyone at Attic Breeze, we thank you for your purchase!

www.atticbreeze.net

877-288-4234