3onedata IES2016-16T Series Manuale di installazione rapida - Pagina 2
Sfoglia online o scarica il pdf Manuale di installazione rapida per Interruttore 3onedata IES2016-16T Series. 3onedata IES2016-16T Series 3. Unmanaged industrial ethernet switch
Stampa la pagina
Attention before mounting:
Don't place or install the device in area near water or
moist, keep the relative humidity of the device
surrounding between 5%~95% without condensation.
Before power on, first confirm the supported power
supply specification to avoid over-voltage damaging the
device.
The device surface temperature is high after running;
please don't directly contact to avoid scalding.
【DIN-Rail Mounting】
For convenient usage in industrial environments, the product
adopts 35mm DIN-Rail mounting, mounting steps as below:
Step 1
Check whether the DIN-Rail mounting kit that
comes with the device is installed firmly.
Step 2
Insert the bottom of DIN-Rail mounting kit (one side
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Step 3
Check and confirm the product is firmly installed on
DIN-Rail, and then mounting ends.
【Disassembling DIN-Rail】
Step 1
Power off the device.
Step 2
After lift the device upward slightly, first shift out the
top of DIN-Rail mounting kit, and then shift out the
bottom of DIN-Rail, disassembling ends.
Attention before powering on:
Power ON operation: first connect power line to the
connection terminal of device power supply, and then
power on.
Power OFF operation: first unpin the power plug, and
then remove the power line, please note the operation
order above.
【Power Supply Connection】
DC power supply
This series of Model I provide 4-pin 5.08mm
pitch power input terminal blocks and two
independent DC power supply systems of
P1 and P2. The power supply supports
anti-reverse
connection
over-current protection. Power supply range: 12~48VDC.
AC power supply
This series of model II support AC single
power supply scheme. They provide 4-pin
5.08mm pitch input terminal blocks with 2
power
supply
pins.
over-current protection. Input voltage of power supply:
220VAC (100~240VAC).
【DIP Switch Settings】
It provides 4-pin DIP switch for function settings,
among which "ON" is enable valid end.
The definitions of DIP switch are as follows:
DIP
Definition
1
Flow control
2
Storm suppression
3
Reserved
4
Reserved
【Checking LED Indicator】
The function of each LED is described in the table as below:
LED
Status
P1/P2
ON
(only for
DC
OFF
product)
ON
RUN
OFF
ON
Link/ACT
Blinking
(1-16)
OFF
and
3A
【Specification】
Panel
100M copper port
It
supports
2A
Indicator
Exchange attributes
Operation
Set the DIP switch to ON, then
the device will reboot and
enable the flow control
function.
Set the DIP switch to ON, then
the device will reboot and
enable the storm suppression
function.
－
－
Description
Power supply is connected and
running normally
Power supply is disconnected and
running abnormally.
Device is running normally.
Device is disconnected and running
abnormally.
Ethernet port connection is active.
Data transmitted
Ethernet port connection is inactive.
10/100Base-T(X) self-adapting
RJ45 port, full/half duplex
self-adaption, support
MDI/MDI-X self-adaption
Power indicator, interface
indicator, running indicator