DT Research LT330 Manuale operativo di base - Pagina 4
Sfoglia online o scarica il pdf Manuale operativo di base per Computer portatile DT Research LT330. DT Research LT330 4. Rugged convertible laptop
Anche per DT Research LT330: Manuale operativo di base (5 pagine)
Stampa la pagina
NVIS Mode and Screen Brightness Control (optional)
•
When power button is pressed to power on the unit, power LED will flash orange
once to indicate the unit is booting. Unit will boot into NVIS mode with zero nit
brightness by default and display will be dark. You can press the "Brightness Up"
and "Brightness Down" buttons to set NVIS mode display to desired brightness
(up to 20 nits).
•
To toggle between NVIS and high-brightness display mode, press the "NVIS/
Normal Mode Toggle" button. When changed from NVIS mode to high-brightness
mode, display brightness percentage will be same as the brightness level set in
NVIS mode before toggling.
•
Use brightness control buttons to set desired brightness level. When changed
from normal display mode to NVIS mode, display brightness will be set to 0 nit
(display is dark) and you need to use brightness control buttons to change display
to desired brightness.
•
Brightness up, Brightness down, NVIS/Normal toggle, Windows Key and Control
Center functions are fixed and not user programmable.
•
Two programmable buttons can be programmed through Button Manager.
Wireless Networking
The LT330 is often delivered with an embedded (user-inaccessible) 802.11 WLAN
adapter equipped with a hidden custom antenna.
•
Through the support of typical WLAN adapters, the LT330 should be able to
detect all 802.11 access points in the vicinity to select the access point of choice
for connection.
•
The SSID and WEP/WPA/WPA2 (if enabled) parameters on the LT330 and the
access points have to match. The SSID is case-sensitive and it is recommended to
enable WEP/WPA/WPA2 encryption (or advanced alternatives) for secure access.
•
When WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly configure
associated settings such as Authentication mode, etc.
•
Refer to the access point operating manuals for setting up the 802.11 access
points.
6
USING THE RUGGED LAPTOP
Peripherals Support
Through its USB 3.0 ports, the LT330 supports a wide range of USB-based
peripherals. These peripherals are applicable for software installation, applications
storage, data storage, and system software recovery and updates.
For More Support
Users can download the Laptop Modules Basic Operation Guides from the DT Research
website.
If the LT330 comes with a Mobile broadband module, please contact your product
and/or service provider for the SIM Card installation procedures.
Federal Communication Commission Interference
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate
this equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
This Class [B] digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.
7