DTC Palladium Pd-TX-100 Manuale - Pagina 4

Sfoglia online o scarica il pdf Manuale per Trasmettitore DTC Palladium Pd-TX-100. DTC Palladium Pd-TX-100 20. Palladium series. cofdm transmitter. 100 mw/250 mw output

Stampa la pagina

QUICK START

Palladium Transmitter, Top View

CAMERA

MICROPHONE(S)

9 AA

BATTERY

PACK

Typical Wiring Configuration

DTC COMMUNICATIONS, INC.

Complete these steps:

1 Connect the transmitter antenna to the SMA connector on the top of the

Palladium unit.

2 If you plan to use audio, connect one or two microphones to the Audio 1

and/or Audio 2 LEMO connectors.

3 Connect power and video input via the Multi I/O cable to the 6-pin

Hirose connector:

a Attach your camera video input (75 ohm composite video source in

PAL or NTSC) to the Multi I/O cable BNC connector.

b Apply the necessary power to your camera and turn ON.

c Attach a 12 VDC power source (such as the supplied battery pack or

the AC power adapter) to the Multi I/O cable via the Molex connector.

The input voltage range is from 10 to 18 VDC.

ANTENNA

NOTE: Eight Channel LEDs are located under the sliding control

panel door. If all 8 green LEDs are flashing, this indicates that your

battery source is low.

Thermal Issues

Higher power Palladium Pd-TX-250 Transmitters feature

mounting tabs for convenient mounting and heat

dissipation. If your Palladium Transmitter has these tabs,

proper heat sink mounting is recommended for optimal

performance. An optional heat sink can be purchased

from DTC. See page 8 for heat sinking instructions.