DTM System NANO II 150 Manuale d'uso - Pagina 14

Sfoglia online o scarica il pdf Manuale d'uso per Ricevitore DTM System NANO II 150. DTM System NANO II 150 16. 1-channel
Anche per DTM System NANO II 150: Manuale d'uso (8 pagine)

Stampa la pagina
2.7. Deleting a single remote control from the receiver's memory
To remove a single remote from the receiver's memory, hold down the receiver button and press the active remote control
button.
1
PRESS AND HOLD C1
LED PULSES
Rys. 6. Deleting a single remote control .
Holding down the receiver button for more than 15 seconds will remove all the remote controls from the receiver.
2.8.Memory format
To format the receiver's memory, press and hold the receiver button for 15 seconds. Release the button only when the light goes
out.
> 15s
1
PRESS AND HOLD C1
EN
LED PULSES
Fig. 7. Memory format.
Memory format:
removers all remote controls from the receiver,
ź
disables the easy remote adding lock,
ź
deletes the Galactic authentication code from the receiver.
ź
2.9. Verifying number of added remotes
To verify number of registered remotes, prior registering or removing remote is required.
After registering or removing remote, hold receiver button for 5 more seconds. LED will blink showing number of registered
remotes. First number of tens (from 0 to 20 long pulses), then number of units (from 0 to 9 short pulses). In the NANO2 version,
the indicator lamp flashes indicating the number of programmed remote controls.
2.10. Receiver management via USB (available only for NANO2 868, NANO2 DUO versions)
The receiver is equipped with a USB connector for connecting MEMO service programmer. Receiver housing is equipped with a
USB socket cover (Figure 1.) which allows connecting MEMO programmer without a need to remove receiver cover.
Connecting MEMO service programmer to receiver allows:
receiver firmware update,
ź
receiver memory backup,
ź
add remotes from a file to the receiver memory.
ź
During the backup and update of the remotes using the MEMO programmer receiver remains inactive, it does not respond to the
signal from the remotes.
2
PRESS REMOTE
ACTIVE BUTTON
AFTER 15 SECONDS
2
C1 LED GOES OUT
- FORMAT SUCCESSFUL
number of tens - 4x10
Fig. 8. Pulses example, showing number of registered remotes - 46.
3
C1 LED GOES OUT
- DELETING SUCCESSFUL
number of units - 6