AIRTRONICS RX-700 Istruzioni per l'uso - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per l'uso per Ricevitore AIRTRONICS RX-700. AIRTRONICS RX-700 4. 2.4ghz fhss-1, 7-channel full-range receiver

Stampa la pagina

transmitter Precautions

Turn the transmitter ON first and then turn the receiver ON. After using your model, turn the receiver OFF first, then turn the transmitter

OFF. It can be dangerous if you activate the components in reverse order as the servos may start up inadvertently.

Before use, double-check that the transmitter and receiver batteries are sufficiently charged.

Never touch the transmitter antenna during use. Doing so may cause loss of transmitter output, making it impossible

to control your model.

Before use, the transmitter antenna should be angled so that the antenna is as close to perpendicular to the

ground as possible during use. This is the optimum angle for use. After use, to prevent any chance of damaging

Keep Antenna

Perpendicular

the antenna, the antenna should be moved into the horizontal stowed position.

to Ground

saFety

Be certain to read these Operating Instructions in their entirety.

'Safety First' for yourself, for others, and for your equipment.

Observe all the rules of the flying site or anywhere you operate your radio control equipment.

If at any time during the operation of your model should you feel or observe erratic operation or abnormality, end your operation as

quickly and safely as possible. DO NOT operate your model again until you are certain the problem has been corrected.

Your model can cause serious damage or injury, so please use caution and courtesy at all times.

If you have little to no experience operating models, we strongly recommend you seek the assistance of experienced modelers or your

local hobby shop for guidance.

BindinG tHe receiver to your transmitter

It is necessary to pair the transmitter and receiver to prevent interference from radio controllers operated by other users. This operation

is referred to as 'binding'. Once the binding process is complete, the setting is remembered even when the transmitter and receiver are

turned OFF, therefore, this procedure usually only needs to be done once for each separate receiver you're using.

The Binding procedure describes binding the receiver to an Airtronics RDS8000 2.4GHz transmitter. If binding the receiver to an

Airtronics SD-10G 2.4Ghz transmitter, please refer to the Transmitter and Receiver Binding section in your SD-10G Operating Manual.

IMPORTANT If binding the receiver to the Airtronics SD-10G 2.4GHz transmitter, the SD-10G transmitter Modulation must first be

changed to FH1. Refer to your SD-10G Operating Manual for more information.

1) Ensure that the throttle control stick is in the LOW position (pulled all the way back). In HELI mode, ensure that the Flight Mode switch

is set to 'N' (Normal).

2) Turn the transmitter ON. The Bind LED on the transmitter will illuminate solid blue.

3) While holding down the Bind Button on the receiver, turn the receiver ON. The

Bind LED on the receiver will blink slowly. After ~2 seconds release the Bind

Button. The Bind LED on the receiver will continue to blink slowly.

Use the tip of a pencil or a 1.5mm hex wrench to press the Bind Button on the receiver.

4) Quickly press the Bind Button on the transmitter. The Bind LED on the receiver will blink rapidly for ~3 seconds, go out momentarily,

then illuminate solid blue, indicating the binding process is complete.

When the binding procedure is successful, the Bind LED on the receiver will stay solid blue when both the transmitter and receiver

are turned ON. If the Bind LED on the receiver is blinking rapidly or not ON at all, the transmitter and receiver are not paired. In this

case, turn both the transmitter and receiver OFF, then repeat the binding procedure.