3onedata TNS5800-16P4GT-2P110 Manuale di installazione rapida - Pagina 2

Sfoglia online o scarica il pdf Manuale di installazione rapida per Interruttore 3onedata TNS5800-16P4GT-2P110. 3onedata TNS5800-16P4GT-2P110 5. Layer 3 rack-mounted en50155 industrial ethernet switch

Stampa la pagina

Model III, Model IV and Model V



Notice Before Mounting:

Don't place or install the device in area near water or



moisture, keep the relative humidity of the device

surrounding between 5%~95% without condensation.

Before powering on the device, check the power



specifications supported by the device to prevent device

damage due to overvoltage.

The device surface temperature is high after running;



please don't directly contact to avoid scalding.

【Install Rack-mounted Device】

Select the device mounting location to ensure

enough size.

Adopt bolts to install the mounting lugs in the

device position as figure below

Place the device on the rack surface plate; adopt 4

screws to mount the right and left mounting lugs on

the rack.

Check and confirm the product is firmly installed on

the rack, then mounting ends.

【Disassembling Device】

Power off the device.

Unscrew the fixed mounting lug screw on the rack.

Shift out the device from rack, disassembling ends.

Notice Before Powering On:

Power ON operation: First insert the power supply



terminal block into the device power supply interface,

and then plug the power supply plug and power on.

Power OFF operation: First, remove the power plug,



then remove the wiring section of terminal block. Please

pay attention to the above operation sequence.

【Power Supply Connection】

Model I and Model II



The Model I and Model II

provide two independent DC

power supply systems, P1

and

reverse connection protection and power redundancy backup.

Power interface adopts 8-pin 5.08mm pitch terminal blocks

(includes 6-pin power supply), pin definition are shown as

above. Power supply input range: 110VDC (66~156VDC)

Model III and Model V



The Model III and Model V provide two

independent DC power supply systems, P1 and

P2, which support reverse connection protection

and power redundancy backup. The power supply

interface adopts M23 7-Pin pin (male) connector. Input voltage

of power supply: 110VDC The pin definitions of M23 (male)

are shown as follows:

Pin No.

Definition

V1+

V1-

V2+

V2-

【Relay Connection】

Model I and Model II



The Model I and Model II

adopt 8-pin 5.08mm pitch

P2,

which

support

GND R2