damixa TB140241 Istruzioni per il montaggio - Pagina 2

Sfoglia online o scarica il pdf Istruzioni per il montaggio per Prodotto idraulico damixa TB140241. damixa TB140241 3. Bath shower mixers

Please note these mixers are not thermostatic and the output temperature is dependant

upon prevailing incoming water temperatures and pressures. Always take care when using

hot water, especially with children. Never leave a child unattended.

Pressure Suitability

These mixers have been designed to give high flow rates at low pressures for bath filling.

For high-pressure systems above 1 bar pressure where water consumption is excessive the

mixer is also provided with a Regul8 flow regulator that limits the maximum flow to 8

litres/min (+/- 10%) for the shower. Simply fit to the shower outlet between the shower hose

and the threaded outlet of the mixer. Fit the Regul8 insert with the holes facing the incoming

water stream and the 'O' ring facing towards the shower hose as shown below.

Installation

Home Safety Advice

Always take care when using an electric drill, particularly in the bathroom. Always check for

hidden cables and pipework before drilling and take extreme care if there is any water in the

working area.

Always wear suitable eye protection when drilling. Unplug any equipment after use.

Installation

1. Turn off all water and any electrical supplies.

2. Identify all components and check to see if complete before starting installation.

3. Where supplied (Ixia and Iona) place the base shrouds onto the inlet tail of the mixers.

4. Fit any sealing washers or gaskets to the mixer and then fit the mixer into the tap holes in the

bath.

5. Fit the metal back nuts onto the tap tails and tighten fully until the mixer is secure.

6. Connect the taps to hot and cold supplies. Isolating valves should be fitted to hot and cold

supply pipes.

7. Fit the waste (not supplied) to the bath.

FI-CX-B6

‐‐ 2 ‐‐