Conairphone TAD1212 Manuale d'uso - Pagina 14
Sfoglia online o scarica il pdf Manuale d'uso per Segreteria telefonica Conairphone TAD1212. Conairphone TAD1212 17. Callkeeper digital answering system
Stampa la pagina
Troubleshooting Guide (Cont.)
PROBLEM
POSSIBLE CAUSE
No remote
Unit is in the "OFF" position
operation
AC adaptor is disconnected
from wall outlet or back of
unit
Power to electrical outlet
may be off
Calling from a phone that is
not outputting tone dialing
(rotary, PABX, cellular).
Telephone line is not
connected to wall jack
Security code not entered
correctly
Remote security code being
used differs from the code
on the bottom of unit
After a power
A 9 volt battery has not
outage, outgoing
been installed or needs
announcement
to be replaced
and incoming
messages are
lost
The machine
The outgoing message
beeps during the
you are recording is too
recording of my
long
outgoing
messages
The machine is
The incoming message
cutting off
is too long
incoming
messages
CORRECTIVE ACTION
Check to verify if message counter is lit.
Reconnect AC adaptor into wall outlet or
back of unit. Try connecting to a different
wall outlet.
Check to see if electrical outlet is
controlled by a light switch and power is on.
Try calling your unit from a different
(non-PABX, non-cellular) phone.
Connect telephone line into wall jack. Try
connecting into a different telephone wall
jack.
3 digit remote security code must be
entered after your outgoing announcement
Press and hold each digit for more than 1
second.
Verify that the remote security code being
used matches the code on the bottom of
the unit.
Install a fresh, alkaline 9 volt battery to
maintain your
outgoing announcement
incoming messages in the event of a power
failure.
Record a shorter outgoing message (less
than 30 seconds).
Maximum recording time for incoming
messages is 45 seconds.
14
and