ADDER AdderLink X-DVIPRO-MS2 Manuale d'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale d'uso per Estensore ADDER AdderLink X-DVIPRO-MS2. ADDER AdderLink X-DVIPRO-MS2 16. Adder pro dvi

5 Connect the link cable (see page 2 for cable advice) to the local module socket labeled

TO REMOTE

CATx link cable

[MS2 variant only] Attach a second

category 6a or 7 link cable (up to 50

meters in length) to the upper socket

on the MS2 local module.

Secondary CATx link cable

Primary CATx link cable

Optional power connection

The X-DVIPRO local module is designed to derive its power from the host computer via

the USB connection (two USB connections in the case of the MS version). If this is not

possible, then you will need to use one or two optional Adder power adapter(s).

Optionally for X-DVIPRO and X-DVIPRO-MS2 units:

1 Connect the output lead of the optional

power adapter(s) to the socket(s) labeled

on the local module.

POWER

X-DVIPRO: Use an optional

power adapter only if

powering from the host (via

USB) is not possible.

Note: After all connections are

made, power up the monitor and

the REMOTE module first (followed

by the LOCAL module, if using the

X-DVIPRO-MS2 variant with power

adapters) and then switch on the

computer.

X-DVIPRO-MS2: Use two

optional power adapters if

powering from the host (via

dual USB connections) is

not possible.

2 Insert the IEC connector of the separate power lead(s) into the corresponding

socket(s) of the power adapter(s). Connect the other end of the power lead(s) to one/

two nearby mains socket(s).

Do not use squid cables or

power splitters. Two separate

power adapters must be used.