ADDER AdderLink X-Series Manuale - Pagina 4
Sfoglia online o scarica il pdf Manuale per Trasmettitore ADDER AdderLink X-Series. ADDER AdderLink X-Series 15. Usb extender
Anche per ADDER AdderLink X-Series: Manuale (18 pagine)
Stampa la paginaInstallation and operation
Installation
The installation of the Dual Video Transmitter is straightforward and can best be
achieved in most cases by following these stages:
• Stage A
Check or set the configuration switch settings
• Stage B
Mount the module
• Stage C
Connect the cables
Stage A - Configuration switch settings
The basic operation of the Dual Video Transmitter is controlled by the bank of
four switches located on the side of the module. The switches are monitored at
all times and may be changed when power is on or off (the only exception to
this rule is switch 1 which initiates slightly different functions depending on the
power state when it is switched).
OFF: Normal operation
ON: Flash upgrade/reset
password modes
OFF: Two-in, two-out mode
ON: One-in, two-out mode
Note: When shipped, all switches are set in the OFF positions and this will
produce normal operation in the 'Two-in, two-out' mode. To select the
alternative, 'One-in, two-out' mode, simply change switch 3 to the ON position.
Switch 1
OFF: Normal operation.
ON: (Before power is applied) Places the module into upgrade mode so that the
ON: (Whilst power is applied) Places the connected receiver modules into
Switch 2
OFF: Normal operation.
ON: Set transparent mode. Use this setting if the Dual Video Transmitter is to be
OFF: Normal operation
ON: Transparent mode
OFF: Normal operation
ON: Reset Dual Video
Transmitter
Switch 3
OFF: 'Two-in, two-out' mode. Use this setting when the computer has a second
ON: 'One-in, two-out' mode. Use this setting when two separate keyboard,
Switch 4
OFF: Normal operation.
ON: Suspend operation and reset the Dual Video Transmitter. Use this setting
internal software can be changed. Please see the 'Flash upgrade' section in
the 'Special configuration' section.
password override mode. This allows any pre-configured passwords to be
altered - particularly useful when they have been lost or forgotten. Please
see the 'Password override' section in the 'Special configuration' chapter.
used with KVM switches that are not manufactured by Adder Technology.
Cascaded KVM switches often use special signals to set or identify
conditions. In transparent mode, the Dual Video Transmitter will pass the
signals without attempting to interpret them.
video controller that must be fed to a second video monitor alongside, or
separate from, the primary monitor, keyboard and mouse.
video and mouse sets are required to control one computer.
momentarily to produce the same effect as removing and restoring power
if incorrect operation has occurred. Return the switch to the OFF position
to allow normal operation to continue.