Anybus Wireless Bridge II Manuale di installazione - Pagina 10
Sfoglia online o scarica il pdf Manuale di installazione per Adattatore Anybus Wireless Bridge II. Anybus Wireless Bridge II 17.
Stampa la paginaConfiguration
4.2
Easy Config
1.
Power on the unit and wait for the Link Quality LEDs to light up and go out
again, then press and release the MODE button.
Step 1 must be carried out within 5 seconds of startup.
2.
Press MODE repeatedly to cycle through the Easy Config modes until the
desired mode is indicated by the A-B-C-D LEDs.
Mode 2 is the first mode, which means that the number of required button
presses are always one less than the mode number.
3.
Press and hold MODE for 2 seconds, then release the button. This will con-
firm the selected mode and restart the unit.
Step 3 must be carried out within 20 seconds of step 2, otherwise the unit
will exit Easy Config setup and return to the previous settings.
4.2.1 Easy Config Modes
Mode
2
3
4
5
6
Modes 4, 5 and 6 are used in combination to automatically set up a WLAN or
Bluetooth network with units of this type.
Modes 5 and 6 will scan for units in Mode 4. Each detected unit in Mode 4 will be
reconfigured as a client, and the scanning unit will be configured as an access
point. The clients will then restart and connect to the access point.
Mode Timeout
•
Mode 5 and 6 will scan for 120 seconds. The mode can be activated repeat-
edly to scan for additional units.
•
Mode 4 will listen for 120 seconds, or until it has received a valid configura-
tion from a unit scanning in Mode 5 or 6.
Anybus
®
Wireless Bridge II
Role
Description
—
Reset configuration to factory defaults
—
Reset IP settings to factory defaults
Client
Wait for discovery and configuration
WLAN AP
Discover units in Mode 4 and configure
them as clients
Bluetooth NAP
The IP address of a client may be changed by the configuration from the
access point. Active browser sessions could therefore be lost.
™
Installation Guide
10 (16)
A
B
C
SCM-1202-013/SP2167 1.1
D