DUCATIHOME 8500V-Rol/ DUCATI UP 70 (CTH29E) Manuale di istruzioni per l'installazione - Pagina 16

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Apriporta del garage DUCATIHOME 8500V-Rol/ DUCATI UP 70 (CTH29E). DUCATIHOME 8500V-Rol/ DUCATI UP 70 (CTH29E) 19. Garage door automation system 70 kg

Stampa la pagina

12. Ref. 6203 Rolling radio remote control

The Ref. 6203 Rolling remote control incorporates 3 radio transmission channels, corresponding to:

1st channel = ON button

2nd channel = OFF button

Each transmission channel, and therefore each button, transmits a unique factory-set code on radio

frequency 433 MHz, using the coding system known as "rolling code".

Each button can be used to operate a different drive unit in the DUCATI range.

The code, which is secret and cannot be copied, is determined automatically from a choice of more than

a billion possible combinations.

This system ensures that only your remote control will be able to open your automatic door.

A) Store the transmission code in your automation system:

First check that the 230V power supply is connected and that the protection fuse is in good

condition.- The door must not be moving,

1) Press the P1 key on the automation system circuit board for 1 second.

The red LED illuminates with a steady light.

2) Release the P1 key

3) Within 8 seconds, hold down the key on your remote control (6203 rolling) that you wish to

use to operate the automation system.

The circuit board's red LED will flash once, then it will remain illuminated and will extinguish

after a few seconds

4) Press again on the remote control to initiate operation

your remote control has been stored in the automation system circuit board memory.

IMPORTANT: The circuit board memory can store a maximum of 10 different codes.

B) Erase the circuit board memory (total erasure of memory):

If the memory is full or if you lose a remote control, the memory must be erased (all the codes will be

erased) and all the codes must be reinput into the circuit board.

The door must be closed and immobile.

Press button P1 for approximately 20 seconds until the LED flashes 1 sec.

Release P1-

All the codes have been erased from the automation system memory. Input the new codes following

steps 1-4

Fig. 49

circuit board

CTH29E

13. Power adjustment

To adjust the automation system's power in accordance with your door's weight and friction in operation,

use the RV1 trimmer on your automation system circuit board.

First perform an opening and closing operation to check whether the power is

adequate for satisfactory operation (if the door stops before reaching the end of

travel, the power must be increased)

Turn RV1 anti-clockwise to reduce the power.

Turn RV1 clockwise to increase the power.

Page 16

red LED

1st button = 1st transmission

channel with a unique "rolling"

transmission code

2nd button = 2nd transmission

channel with the second unique

"rolling" transmission code

Fig.50

RV1