AnyLeaf Water Monitor Manuale d'uso - Pagina 2

Sfoglia online o scarica il pdf Manuale d'uso per Accessories AnyLeaf Water Monitor. AnyLeaf Water Monitor 6.

To get started, connect the three sensors that use cylindrical connectors (BNC) to

the Water Monitor. Left-to-right, with the screen facing you, and the ports at the

bottom: conductivity (black sensor), ORP (teal sensor), pH (clear sensor). If not

already connected, connect the temperature sensor (A 3-wire resistance

temperature detector (RTD)) to screws on the left side, using a Phillips-head

screwdriver; the blue terminal is on the top.

Connect power by plugging the Water Monitor into wall power, or a PC, using the

USB-C Port. Press the control switch inwards to power on the device. You will see

four readings. When taking measurements, unscrew the caps on the probes, and

place the probes into the water you'd like to measure. If you don't need a certain

measurement, you can leave that probe disconnected.

The Water Monitor can be powered over USB using its USB-C port, or using 3 AA

batteries, which are included in the package. You may use rechargeable batteries,

but the Water Monitor will not charge them; you must charge separately. The

Water Monitor will operate for about 6 weeks on a single set of batteries.

Display

The Water Monitor uses a 4.2" e-paper display. This allows it to hold an image on

the display without using any power, providing a long battery life. As a

consequence of the way this display operates, every few screen refreshes (eg

when a reading change, or you navigate in the menu), the screen will flash white-

black-white for 1-2 seconds. This is called a full refresh, and is normal. The

readings may become blurry during refreshes where this doesn't occur. Note that

a full refresh will occur once readings have stabilized.

Interface

You can change settings on the Water Monitor using the 5-way control switch,

located to the left of its screen. From the home page, move the stick right to

enter the menu. In the menu, move the stick up or down to select different

items; the selected item is indicated by a carat to its left. Press forward to access

or toggle the item, and press back to go to the home page. Selecting a unit to

change will toggle that unit. Selecting a calibration process will enter that

Page 2 / 6