Duco DucoBox Silent 325 Manuale di installazione - Pagina 10
Sfoglia online o scarica il pdf Manuale di installazione per Ventilatore Duco DucoBox Silent 325. Duco DucoBox Silent 325 12.
Anche per Duco DucoBox Silent 325: Manuale di avvio rapido (16 pagine), Manuale di installazione (16 pagine), Manuale di installazione (16 pagine)
Stampa la pagina
ENGLISH
Press 'HIGH' or 'LOW' to activate the configuration mode for 30 minutes�
Then close the cover firmly.
Which configuration mode should I choose?
Button
3
The percentages in the table indicate what percentage of the flow rate configured will be extracted�
The configuration mode chosen does not affect the operation of the AUTO mode�
* In the 'LOW' configuration, the percentage in low mode and boost mode is dependent on the type of
home (see section "06�D Setting type of home" on page 7) and limited to the maximum achievable
ventilation system flow rate�
Close the DucoBox cover�
4
Ensure it forms an airtight seal with the DucoBox�
Select the duct with the highest flow rate and restriction�
5
Measure at the vent and adjust the DucoBox rpm until the desired flow rate is
obtained� This can be done in two ways:
• Using the
Humidity Sensor*�
6
• Using the 'DOWN' and 'UP' buttons on the DucoBox� This requires the cover to
be removed temporarily� Always close the cover after every measurement.
Pressing the buttons once is equal to 1% (= approximately 2 to 3 m³/h per press of the button depending
on the restriction in the ducts)�
Now measure the other vents� The flow rate from these other vents must only be
7
adjusted at the vents themselves.
8
Repeat steps
Exit configuration mode� This can be done in two ways:
• Long-press 'AUTO' on a paired User controller or CO
the 4 LEDs light up white briefly and then turn yellow again�
• Press 'ENTER' in the DucoBox and then immediately close the cover on the
DucoBox� If the cover was not closed, you can pull the plug out of the power
9
socket for a few seconds after closing the cover in order to reboot the DucoBox�
The DucoBox will now perform a calibration by speeding up high� This may take up
to 1�5 min� Calibration will be complete once the DucoBox slows down the 'AUTO'
button LEDs on the User controllers / CO
will the LED on the DucoBox�
* Depending on the software version of the User controller / CO
10
L2000651 Installation guide for DucoBox Silent (Revision M | 17.07.2019)
Air calibration using 'HIGH'
This method is standard and has the
lowest consumption� Recommended
in the majority of homes�
Low mode (10%)
Medium mode (50%)
High mode (100%)
(lower) and
(higher) buttons on a paired User controller or CO
and
until the desired flow rate has been obtained at each vent�
6
7
/Humidity sensor�
2
Air calibration using 'LOW'
This method offers a boost mode
but may give rise to more noise
and higher consumption�
Low mode (14-33%)*
High mode (100%)
Boost mode (143-333%)*
/Humidity sensor* until
2
/Humidity sensors* will turn white, as
2
HIGH
LOW
/
2
ENTER
/
/