Concoa 529 5106-01-220 Manuale di installazione e istruzioni per l'uso - Pagina 5

Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Sistema di sicurezza Concoa 529 5106-01-220. Concoa 529 5106-01-220 13.

Stampa la pagina
OPTION 1 (continued)
Cut the 4 conductor cable to length. Remove the outer jacket of the cable to expose approximately 11⁄2
inches of the internal conductors. Strip away 1⁄4 inch of the insulation on each of the 4 conductors. Tin
the leads of the conductors. Slide the protective cover, cable retainer, and locking nut for the circular
connector over one end of the cable as shown in Figure 2.
SYSTEM
LEFT BANK
RIGHT BANK
Using the pin assignments shown in Table 1 and the connector views in Figure 3 and Figure 4, solder
the wires to the appropriate pins. After soldering is complete attach the cable cover, cable retainer, and
locking nut to each of the circular connector plugs.
Plug the Input Connector side of the cable (6 pin connector) into the Remote Alarm and secure it by
turning the locking nut until it locks. Plug the 4 pin circular connector into the Switchover securing it
by turning the locking nut until it locks.
OPTION 2: For Autoswitch Systems that have a 6 pin circular connector.
It will be necessary to obtain a 6 conductor cable. The length of the cable is etermined by the application,
but should be limited to no longer than 1500 feet. It is recommended that 22 AWG stranded wire be
used. (Alpha #5006C or Belden #8446 are acceptable types.)
Cable Retainer Tabs
Cable Cover
Cable Retainer
notch
Figure 3
Switchover
Connector Pin #
2
---
3
---
1
4
Locking Nut
Figure 2
Table 1
Remote Alarm
Connector Pin #
1
---
4
---
3
6
-5-
Plug
notch
Figure 4
Function
LBSW status
alarm
RBSW status
alarm
+12
Gnd