Concoa 529 5106-01-220 Manuale di installazione e istruzioni per l'uso - Pagina 8

Sfoglia online o scarica il pdf Manuale di installazione e istruzioni per l'uso per Sistema di sicurezza Concoa 529 5106-01-220. Concoa 529 5106-01-220 13.

Stampa la pagina

CONFIGURING THE REMOTE ALARM

The Single Station Remote Alarm can be configured to allow connection to either Normally Open (N.O.) or

Normally Closed (N.C.) pressure switches.

Setting the Alarm for Normally Open or Normally Closed Pressure Switches

The Single Station Remote Alarm is factory set to operate with Normally Closed (N.C.) pressure switches. To

configure the alarm to operate with Normally Open (N.O.) pressure switches perform the following steps:

1. Unplug the power plug from the Remote Alarm power jack.

2. It is best to set the unit on a flat surface face down. Remove the four (4) screws that hold the back cover

on and set the cover aside.

3. Locate the 4 position DIP switch array and then using a stylus or small screwdriver open and close the

DIP switches according to Table 9A, 9B and Figure 9.

5. Place the back cover back onto the base and tighten the screws.

6. Reconnect the power plug into the power jack and plug the unit in.

Figure 9

Table 9A

Settings for Normally Open (N.O.) Operation

DIP Switch

*OFF = Open, ON = Closed

Table 9B

Settings for Normally Closed (N.C.) Operation

DIP Switch

*OFF = Open, ON = Closed

-8-

Factory Default Settings

Open

Factory Default Settings

Open