AnyTone AT-5555 Manuale di istruzioni - Pagina 12
Sfoglia online o scarica il pdf Manuale di istruzioni per Radio AnyTone AT-5555. AnyTone AT-5555 17. 10 meter radio
Stampa la pagina
FUNCTION MENU SETUP
The initial functions and parameter can be changed via the following
settings and operations. Please read the following instruction before
making any desired amendments.
To enter Function Menu: under ON state, press and hold FUNC key for
more than 2seconds, and then release the FUNC key to enter into the
Function Menu Setup. Under this condition, press FUNC key to select
different functions menu, CHANNEL SELECTOR Switches to change
the data of Function Menu.
(01) ICG
This menu refers to MIC GAIN function.
Users can set the value by software. The
higher value goes to higher sensitivity. 64
grades in total (OFF,0-63)
Default: 41
(02) UOL
9
This menu controls the VOX sensitivity from
level OFF to 9.
Default: OFF
(03) UOT
This menu controls the VOX delay time
from level 1 to 9.
Default: 04
(04) RCDT
This menu refers to RX CTCSS and DCS
code setting.
Default: OFF
(05) TCDT
This menu refers to TX CTCSS and DCS
code setting.
Default: OFF
(06) NC
This menu refers to RX noise compander
setting.
Default: OFF
(07) NG
This menu refers to TX noise gate setting.
Default: OFF
(08)
NR(only for model AT-5555
This menu refers RX noise reduction setting
Default: OFF
(09) ICP
This menu refers to microphone type setting.
EL: electronic type, DY: dynamic type
Default: OFF
OFF 改为 DY
(10) NOG
It refers to TX MON function. Users can set the
volume and grade of the TX MON by software.
The higher grade goes to louder TX MON.
64 grades in total (OFF,0-63)
Default: OFF
(11) CSU
This menu is to adjust the side voice of CW
SIDE VOL CW. 64 grades in total.
Default: 31
(12) BEU
This menu is to set the volume of prompt
voice. 64 grades in total(OFF,0-63).
Default: 31
PLUS/N)