Anywave ATSC 140W Manuale di avvio rapido - Pagina 10

Sfoglia online o scarica il pdf Manuale di avvio rapido per Trasmettitore Anywave ATSC 140W. Anywave ATSC 140W 13.

and verify that the voltages (Vol_9 and Vol_50) and current (Cur1_50) are
showing real values and not all 0s.
6. You are now ready to bring the TX up to power. To accomplish this, slowly
increase the drive level out of the Exciter by increasing the POWER setting in
the Exciter RF submenu while watching the PA_Fwd power increase
accordingly on the PAC submenu (you will need to navigate between the Exciter
RF and PAC submenus).
Begin to slowly raise the FWD System power by using the UP button on
the Exciter, while monitoring the PA_Fwd system power meter on the
Controller HOME screen as shown below.
7. Continue to slowly raise the FWD power until you reach the full 140W, or your
desired TPO. Be careful to make small increases in the value of POWER as you
approach the desired output level.
8. Check the SNR and Shoulder (LIMD and UIMD) RF performance of your
system on the Exciter hi level status screen as shown below. Linear and Non-
Linear corrections were already performed and optimized at a TPO of 140W in
the factory and so the stored correction coefficients should produce good results.
If you are operating at a TPO less than 140W and wish to rerun corrections,
please proceed with the following steps, otherwise please skip ahead to step 12.
ACT-140-QSG-DOC-V1.3, 09/29/2014
ATSC 140W TX Quick Start Guide
Page 10 of 13
Slowly increase
to raise FWD
SYS POWER
Monitor FWD
SYS POWER