Dancing Wings Hobby SCG34 Manuale di istruzioni - Pagina 4
Sfoglia online o scarica il pdf Manuale di istruzioni per Aerei Dancing Wings Hobby SCG34. Dancing Wings Hobby SCG34 8. Balsawood scale airplane
Stampa la pagina03-3
2mm
插入舵面，连接处用胶带固定住，并调整间隙。
Plug control surface,fasten the joint with tape,
and adjust the gap.
X2
03-6
去掉胶带，调整摇臂与舵面垂直。
Remove tape, adjust rocker arm,
keep it vertical with surface.
03-8
润滑油
Lubricant oil
Epoxy glue
后续此配件相同安装
Same installation way
in following steps for
this part.
在针式铰链结合处打润滑油（防止胶水焊死）。
使用环氧树脂胶安装和固定针式铰链前，请先确认舵面可以自由摆动。
Add some lubricating oil in the joint of needle type hinge.(Avoid the glue
stuck dead.)
Before install and fasten the needle type hinge with epoxide-resin glue ,
pls confirm the rudder surface can swing freely in advance.
03-9
X2
5
03-4
M1.5
在图示位置钻孔，并用自攻螺丝
固定。
Drill hole as shown, and fasten
03-5
with self-tapping screw.
自攻螺丝
Self-tapping screw
M3x10mm
03-7
螺丝
Screw M4x45mm
03-10
垂直尾翼安装到机身尾部，
用环氧胶粘固，并保持尾翼
可以自由摆动。
Epoxy glue
Install vertical tail wing on
the tail of fuselage, fasten
with epoxy glue, and keep
the tail wing swinging
freely.
04
机翼安装
Assemble the wing
04-1
润滑油
Lubricant oil
04-3
X4
自攻螺丝
Self-tapping screw
M3x10mm
04-5
X2
在机翼正反面的预留孔处安装8字环，用螺丝固定。
Install "8" shape rings on the prepared holes in both sides of wing, fasten with screws.
04-2
Epoxy glue
如上图安装副翼舵机，粘贴木块辅助安装。
Install aileron's servo as shown, stick wood block as an
auxiliary.
装入副翼，保持副翼可以自用摆动。
Install aileron, keep it swinging freely.
04-4
螺丝 Screw
M3*10mm
螺丝 Screw+自锁螺母 Self-locking nut
M3*15mm
X4
螺丝 Screw
M3x10mm
6