Cascade E Series Manuale di istruzioni per l'installazione - Pagina 5

Sfoglia online o scarica il pdf Manuale di istruzioni per l'installazione per Apparecchiature industriali Cascade E Series. Cascade E Series 12. Push/pull and carpet pole removal and installation
Anche per Cascade E Series: Manuale di istruzioni per l'installazione (14 pagine), Manuale di istruzioni per l'installazione (11 pagine), Istruzioni per l'installazione (2 pagine), Manuale dell'operatore (20 pagine)

Stampa la pagina
I
NSTALLATION
3
Mount Attachment on
truck carriage
A
Center truck behind attachment.
B
Tilt forward and raise carriage into position.
C
Engage top mounting hooks with carriage.
Make sure center locator tab engages
center notch on top carriage bar.
D
Lift Attachment 2 in. (5 cm) off pallet.
ITA Class II – 0.60–0.66 in. (15–17 mm)
ITA Class III – 0.72–0.78 in. (18–20 mm)
ITA Class II – 0.32–0.36 in. (8–9 mm)
ITA Class III – 0.39–0.43 in. (10–11 mm)
4
Install and engage lower hooks
QUICK-CHANGE TYPE
Slide hook up
to engage
bar, install
pin in upper
hole (locked).
213372 Rev. 1
Center
Notch
Truck
Carriage
GA0035.ill
Inspect hooks for
excessive clearance.
(Reverse guides to reduce
clearance – see Step 2.)
Lower
Carriage
Bar
e
®
a d
s c
c a
- 1
1 4
5 5
6 7
C -
SD0065.ill
C
SD0070.ill
BOLT-ON TYPE
Tap into position, then
add clearance for
sideshifting:
3/32 in. (2.5 mm) min.
3/16 in. (5 mm) max.
3/16 in.
(5 mm)
max.
Tighten Capscrews:
Class II / III – 120 ft.-lbs. (165 Nm)
B
A
SD0071.ill
C
Upper
Bearings
SD0023.ill
(if fitted)
Lower
Carriage
Bar
S T
J U
A D
SD0066.ill
C
3