Addictive audio 5.2 Manuale di istruzioni - Pagina 3

Sfoglia online o scarica il pdf Manuale di istruzioni per Amplificatore per auto Addictive audio 5.2. Addictive audio 5.2 13. Stereo/mono bridgeable high power car amplifier

Stampa la pagina

DESIGN FEATURES

4 CAR AUDIO AMPLIFIER :

This amplifier allows the crossover controlled amplification of satellite speaker systems,

kickwoofer or subwoofer systems

4 FULL-MOSFET CIRCUITRY :

This amplifier line features a full MOS-FET circuitry layout, implementing MOS-FET's

for power supply, to guarantee excellent sonic performance and very high power output

4 LOAD STABILITY :

This amplifier line up features models that work stable and reliable into very low

impedance loads. Due to the high damping factor, every model of this amplifier line will

guaranteed to have full control over the connected speaker system(s)

4 INTEGRATED ELECTRONIC CROSSOVER :

The internal crossover section features independently selectable highpass filtering, as

well as full range loop through. All x-overs feature crossover slope rates of 12 dB/octave

4 UNCOMPROMISING DESIGN AND CONSTRUCTION :

Only best electrical and electronic components have been used for the assembly of

this amplifier line.

4 ADVANCED PROTECTION CIRCUITRY :

The protection circuitry safe-guards the amplifier from short-circuits at the speaker

outputs, DC offset voltage at the outputs and overheating of power electronics

4 STATUS AND PROTECTION LED'S:

A green and a red LED located at the side panel enable you to monitor the operating

status of your amp

4 ADJUSTABLE INPUT SENSITIVITY :

in order to achieve maximum signal-to-noise performance "LEVEL" control adjusts

the signal level from your headunit to match the amplifier's sensitivity.

IT IS NOT A VOLUME OR POWER CONTROL!!

To adjust, proceed as follows:

a. Set input "LEVEL" control to "MIN".

b. Turn your headunit's volume to maximum level. If distortion is heard decrease

headunit's volume until the sound is clear.

c. Turn the "LEVEL" control toward "MAX" in stages, until the onset of audible distortion

is heard, then decrease to level prior to the point of audible distortion.

NOTE:

not performing above adjustment procedure and/or simply setting "LEVEL"

control at or near "MAX" position, may induce electrical audio noise into the

system or break down of the amplifier because driving the amplifier to distortion.

- 3 -