Addie Water Systems TIG56SXT-S Manuale - Pagina 9

Sfoglia online o scarica il pdf Manuale per Sistema idrico Addie Water Systems TIG56SXT-S. Addie Water Systems TIG56SXT-S 19. Chemical free iron & sulfur reduction

Stampa la pagina

Error

Code

Type

Cam

The valve drive took

Sense

longer than 6 minutes

Error

Cycle

Step

Error

Regen

Failure

regenerated for more

Memory

Error

Upper

Power failure install

Drive

programming change

Sync

Resets

Soft Reset: Press and hold the Extra Cycle and Down Buttons for 25 seconds while in normal service mode.

This resets all parameters. Check and verify all parameters in master programming.

Master Reset: Hold the Extra Cycle button while powering up the unit. This resets all parameters. Check and

verify all parameters in mater programming

Cause

to advance to the

next regeneration

position.

The control

experienced an

unexpected cycle

input

The system has not

than 99 days

Control board

memory failure

Troubleshooting

Unplug the unit and examine the power head. Verify that all

cam switches are connected to the circuit board and

functioning properly. Verify that the motor and drive train

components are in good condition and assembled properly.

Check the valve and verify that the piston travels freely.

Replace /reassemble the various components as necessary.

Plug the unit in and observe its behavior. The unit should cycle

to the next valve position and stop. If the error re-occurs,

unplug the unit and contact your water treatment dealer.

Unplug the unit and examine the power head. Verify that all

cam switches are connected to the circuit board and

functioning properly. Enter Master Programming mode and

verify that the valve type and system type are set correctly

with regard to the unit itself.

Step the unit through a manual regeneration and verify that it

functions correctly. If the error re-occurs unplug the unit and

contact you water treatment dealer.

Perform a manual regeneration to reset the error code.

Enter the Master Programming Mode and verify that the unit

is configure properly.

Perform a Master Reset and reconfigure the system via Master

Programming mode. After reconfiguring the system, step the

valve through a manual regeneration. If the error re-occurs

unplug the unit and contact your local water treatment dealer.

Valve will automatically recover.

Reset and Recovery