Danfoss 084B7704 Istruzioni - Pagina 3

Sfoglia online o scarica il pdf Istruzioni per Controllore Danfoss 084B7704. Danfoss 084B7704 4. Programming tools

Continued

10. Press the 'Source...' button and the EKC is selected

automatically (appears in the 'Source' section)

11. Press the 'Dest...' button, enter a file name for the

setting file (max. 8 characters) and press the 'Save'

button

12. Press the 'Copy' button to copy settings from EKC to

setting file

13. Return to the main screen

14. Exit AKM

15. Integrate the setting file with EKC programming

software (see procedure below)

16. Program an EKC with Danfoss factory settings using

EKC programmer software (see procedure further

below)

17. Verify that all settings in the EKC are correct by

manually reading all parameters of the EKC

Integrate the setting file with EKC programming software,

following this procedure:

1. Start a file browsing programme, e.g. 'Windows

explorer'

2. Copy the setting file (extension '*.akc') from the

AKM-folder (default folder: 'C:\AKM\AKBCKUP') to

the setting file folder of the EKC programmer (default

folder: 'C:\Program files\EKC programmer\setting

files')

3. Rename the setting file to any name not exceeding

255 characters, keeping the '*.akc' extension

4. Close the file browsing programme

➌

Program EKC with EKC programmer software using the following procedure:

1. Start EKC programmer software

2. Connect the EKC to the programming tool (never connect power-connector before termination module)

3. Press the 'Browse' button to select the setting file

4. Press the 'Start Programming' button

5. The 'Status message' box turns green to inform that the EKC has been successfully programmed. This lasts

approximately 2 seconds with EKC 101 and approximately 80 seconds with other EKC's.

➍

For additional information on using AKM, please refer to AKM manual supplied by Danfoss.

For additional help on using EKC programmer, please refer to the online help following the EKC programmer software.

Minimum requirements to PC:

PC of type 80586 / Pentium with at least 32 MB RAM (64 MB, if Windows 2000 or NT) and possibility of a serial and a

parallel connection.

Operative system: Windows 95 or newer windows version.

EKC programming tool

Programming EKC with EKC programmer