Duke FLM200 Foglio di istruzioni - Pagina 5

Sfoglia online o scarica il pdf Foglio di istruzioni per Attrezzature per alimenti commerciali Duke FLM200. Duke FLM200 8.

INSTALLATION OF NEW LIGHT/GASKET

To Determine which light assembly to use, for

which side, the wire should be coming out of

the end of the gasket closest to the counter top.

Light Wire

Once you have selected the correct light route

the wire through the aluminum extrusion and

then through the grommet in the counter top.

NOTE: The front glass may need to be

lifted slightly to allow for easier routing of

the wire.

Begin pushing the gasket onto the edge of the

front/curved glass, making sure the gasket is

pushed all the way onto the glass.

Use masking tape to tape the outer face of the

gasket to the outer face of the curved/glass to

keep it held in place.

Installation and Operation of: Product Name

Remove the bottom 2" of backing paper from

the adhesive at this time but do not remove

anymore. Pull the loose backing paper to the outer

face of the front curved/glass and use masking tape

to tape it down out of the way.

Slide the side glass into its original position

making sure it is properly resting in the grooves

of the cabinet frame and the notches in the glass

line up with the holes on the cabinet flange and

loosely install screw and acorn nut.

DO NOT tighten screws at this time.

Note: if installing glass onto the side that

attaches to the adjacent hot food unit,

DO NOT install screws until later when

the cabinet is slid back into the lineup.

Peel the remainder of the backing paper from

the adhesive and press the side glass onto the

adhesive. Apply significant pressure along entire

gasket profile to make sure that it is properly

adhered to the gasket.