Duke CSW-2 Manuale di installazione e funzionamento - Pagina 6

Sfoglia online o scarica il pdf Manuale di installazione e funzionamento per Scaldapiatti Duke CSW-2. Duke CSW-2 8. Dri-well counter top soup warmer

Installation and Operation of: Counter Top Soup Warmer

Operating temperatures permit safe installation of this holding unit with 0" of spacing be-

tween the unit and a combustible wall or partition.

CAUTION

Electrical:

• The voltage and wattage ratings of this holding unit are given on the device nameplate.

• Connect the holding unit to a circuit having a voltage similar to that stamped on the

device nameplate.

• Connections to supply line are to be made through the power cord supplied on the unit.

The holding unit is not fused and consequently must be connected to a fused circuit

equipped with suitable disconnect means, as required by local code authorities.

CAUTION

1. All foodservice equipment should be operated by trained personnel.

2. Do not allow your customers to come in contact with any surface labeled "CAUTION HOT".

3. Do not cook, warm or hold food directly in wells.

4. Never hold food below 150°F.

5. Always place covers on pans when not serving to prevent food from drying out and to

reduce your operating costs.

6. For most efficient operation, keep empty, covered pans in each pan location during

preheating and when a pan location is not in use.

7. The unit is shipped with Factory control settings that will hold soup at approximately

155° F under normal conditions.

8. The most satisfactory control settings must be determined by experience based on the

nature of the foodservice and the type of operation as well as individual preference of the

restaurant operator. The proper control setting necessary to keep foods at the desired

temperature will vary dependent upon the frequency of turnover, size of food contain-

ers, amount of food in each container, room temperature, location of holding unit with

respect to range or other heated equipment, air outlets, fans, doors and passageways.

INSTALLATION - continued

Do not install the holding unit near any combustible objects or surfaces affected

by heat or moisture.

GENERAL INSTRUCTIONS

Never pour water into wells.

This unit is designed for dry heating only.