AOG T series Manuale di avvio rapido - Pagina 2
Sfoglia online o scarica il pdf Manuale di avvio rapido per griglia AOG T series. AOG T series 2. Post outdoor gas grill
Anche per AOG T series: Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine), Manuale di avvio rapido (2 pagine)
Stampa la pagina
Cooking Grid
Vaporizer panel
Main burner
Warming
rack
Sideburner shelf
(if equipped)
Drip tray
heatshield
Drip tray
Fig. 4-1
Read setting
Read setting here
here
OFF
Fig. 5-1 - Burner valve control knob
WHEN OPERATING THIS
APPLIANCE WITH PROPANE,
ALL INSTRUCTIONS AND
WARNINGS MUST BE
OBSERVED. FAILURE TO DO
SO MAY RESULT IN A FIRE
OR EXPLOSION CAUSING
SERIOUS INJURY OR DEATH.
6-Propane Safety
Gas Cylinders
IMPORTANT: READ AND FOLLOW ALL WARNINGS PROVIDED WITH THE PROPANE-GAS CYLINDER.
READ ALL SAFETY INSTRUCTIONS AND WARNINGS REGARDING THE USE OF PROPANE GAS FOUND IN
YOUR OWNER'S MANUAL.
REV 0 - 1602080910
Backburner
(if equipped)
Rotisserie kit
(if equipped)
5-Test
Note:
DO NOT turn on more than one valve at a time for either electronic or manual lighting.
1. Open lid(s) or remove cover(s) from burner(s) to be lit.
2. Turn all gas control knob(s) to their OFF position(s).
3. Turn on the gas at its source.
4. Depress the desired control knob, then while pressing turn it counterclockwise to the HI LIGHT
HIGH to
High to
position. Once the burner lights, release the knob.
LIGHT
light
Note:
Turning the knob will create a "click" sound. The pilot will ignite at this point, lighting the burner.
CAUTION:
If a burner does not light within two to three (2-3) seconds of turning on the control knob,
depress the knob and turn it to the OFF position. WAIT FIVE (5) MINUTES before
repeating step 4. If you smell gas, follow the instructions on the cover of the grill owner's
manual. If the burners still do not light after several attempts, refer to the grill owner's
manual for manual lighting.
5. Repeat step 4 for each additional burner to be lit.
Sideburner
control know
(if equipped)
main burner
control knob
30
and 36
"
4-Grill Setup
Parts Placement Checklist
Place the following items according to their position and orientation in
Fig. 4-1:
Vaporizer panels, cooking grids, and warming rack.
Leave pre-installed burners in place to maintain proper alignment.
Vaporizer Panels
Place the vaporizer panels directly onto the studs on the burners. The
panels allow heat from the burners to be evenly directly throughout the
cooking area.
Cooking Grids
Place the cooking grids (over the burners) onto the grid frame.
Warming Rack
The warming rack comes pre-installed. Remove zip ties before use.
Consult the owner's manual to remove or replace.
IMPORTANT: See your owner's manual for complete installation
details.
The burner ports and
carry-over ports must
be kept clean to ensure
proper ignition and
operation.
Replacement parts can
be ordered from your
local AOG dealer.
Center main burner
control knob
Left
Drip
tray
model controls
"
Connect
Igniter wire
Screws
Air shutter
Venturi
Fig. 4-2
Right
main burner
control knob
Backburner
control knob
(if equipped)
Control panel
screw(s)
Fig. 5-2
Orifi ce
L-C2-484