Duncan SLS-1 Schema di cablaggio

Sfoglia online o scarica il pdf Schema di cablaggio per Accessori per strumenti musicali Duncan SLS-1. Duncan SLS-1 2. Pickup lipstick tube for strat

Wiring Diagram for

Pickup Models:

SLS-1 Lipstick Tube

for Strat

5427 hollister avenue, santa barbara, ca 93111

tel 805.964.9610 fax 805.964.9749

www.seymourduncan.com

Fig. 1

Confused? Watch the free installation videos on

the Seymour Duncan website (under "Support").

You'll see how Seymour himself does it and you'll

learn lots of great tech tips.

Congratulations on your purchase of a fine, hand-built, Seymour Duncan electric guitar pickup! Installing

this pickup in your guitar isn't rocket science. And, if you're already handy with tools, it'll be a snap for

you–and fun too! But if you have no experience handling red-hot soldering irons, you'd be well advised

to take your new pickup and your trusty guitar to a qualified guitar tech.

The basic steps include:

1. Remove the old strings from your guitar.

2. Unscrew and remove the pickguard and carefully turn it over, taking care not to

scratch your guitar's finish.

3. De-solder the original pickup's wires and make sure to remember where they

were connected.

4. Remove the original pickup from the pickguard.

5. Put the Seymour Duncan pickup into the pickguard.

6. Tin the wires from your Seymour Duncan Pickup and then solder them into place

(see Fig.1).

7. Put the pickguard back in place, taking care to tuck in loose wires.

8. Re-string your guitar and adjust the pickup height so that your new pickup

balances with the other pickups in the guitar. The bridge pickup should be

between 1/8" and 1/16" from the strings and the neck and middle pickups

should be adjusted to achieve the best balance with the bridge pickup.

Strat and Fender are registered trademarks of FMIC, with which Seymour Duncan is not affiliated.