Introduction
1
1
1 Introduction
1.1 Purpose of the Manual
This installation guide provides information for quick instal-
lation of a VLT
frequency converter.
The installation guide is intended for use by qualified
personnel. Users are assumed to be familiar with the VLT
frequency converter, with CANopen technology, and with
the PC or PLC that is used as a master in the system.
Read the instructions before installation and ensure that
instructions for safe installation are observed.
®
VLT
is a registered trademark.
1.2 Additional Resources
Resources available for the frequency converters and
optional equipment:
•
The VLT
Operating Instructions provide the necessary
information for getting the frequency converter
up and running.
•
The VLT
Guide provides detailed information about
capabilities and functionality to design motor
control systems.
•
The VLT
Programming Guide provides greater detail on
working with parameters and many application
examples.
•
The VLT
provides information about installing the
CANopen and troubleshooting.
•
The VLT
provides information about configuring the
system, controlling the frequency converter,
parameter access, programming, troubleshooting,
as well as some typical application examples.
Supplementary publications and manuals are available
from Danfoss. See vlt-drives.danfoss.com/Support/Technical-
Documentation/ for listings.
2
®
CANopen MCA 105 interface in the VLT
®
AutomationDrive FC 301/FC 302
®
AutomationDrive FC 301/FC 302 Design
®
AutomationDrive FC 301/FC 302
®
CANopen MCA 105 Installation Guide
®
CANopen MCA 105 Programming Guide
Danfoss A/S © 05/2015 All rights reserved.
®
VLT
CANopen MCA 105
1.3 Product Overview
1.3.1 Intended Use
®
This installation guide relates to the CANopen interface.
Ordering numbers:
®
•
•
CANopen is a low-level network that standardises only
communications between industrial devices (sensors, limit
switches, motor controls) and high-level devices
(controllers). Configure CANopen systems to operate in a
master-slave or in a distributed control architecture using
peer-to-peer communication.
The CANopen interface is designed to communicate with
any master abiding by the CANopen standard.
®
VLT
CANopen MCA 105 is intended for use with VLT
AutomationDrive FC 301/FC 302.
1.3.2 Items Supplied
When the fieldbus option is not factory mounted, the
following items are supplied:
•
•
•
•
•
•
1.4 Approvals and Certifications
More approvals and certifications are available. For more
information, contact a Danfoss local partner.
130B1103 (uncoated)
130B1205 (coated)
Fieldbus option and connector.
LCP cradle.
Front covers (in various sizes).
Stickers.
Accessories bag (including EMC bracket).
Installation guide.
®
MG33J402
Stampa la pagina