Danfoss VLT5000FLUX Manuale di istruzioni - Pagina 4

Sfoglia online o scarica il pdf Manuale di istruzioni per Azionamenti in corrente continua Danfoss VLT5000FLUX. Danfoss VLT5000FLUX 16.

Install the two mounting brackets on the drive

chassis and then install the bottom duct adapter

on the bottom of the drive as shown in Photo 5.

The installation of the bottom plate is easier while

the back panel is outside the enclosure.

curved leading edge of the bottom duct adapter is

to the front of the drive and down. IMPORTANT:

Install the bottom plate after the drive has been

installed on the back panel to assure proper gas-

ket coverage.

Before installing the back panel with the drive in

the enclosure, remove and discard the rear-most

screws (Photo 6) that are located on the top cover

of the drive. The holes will be used to fasten the

top ductwork with longer screws provided with the

kit.

Photo 7. Drive installed

in cabinet—D4 Frame

Instruction No: 175R5640 V3

The

Install the backpanel in the enclosure (Photo 7).

Use Rittal PS4593.000 brackets (minimum one

per side at the middle of the drive) with

appropriate support strip for additional support

of the backpanel. For the D4 frame use two

supports per side. Consult the Rittal manual for

additional support requirements if additional

components are mounted on the same back

panel.

Aug 13, 2008

Page 4

Attached to chassis brackets

Photo 5. Bottom duct adapter in-

stalled

Photo 6. Top of IP00/Chassis drive