Danfoss REPI-4 Scheda tecnica - Pagina 3
Sfoglia online o scarica il pdf Scheda tecnica per Termostato Danfoss REPI-4. Danfoss REPI-4 4.
Anche per Danfoss REPI-4: Manuale (3 pagine)
Stampa la pagina
Data sheet
Parameter table (continuous)
Specification
Mounting
© Danfoss | 2022.05
REPI Series Digital Thermostat Manual
Override output value when bypass PID control
30
Display output value when enable PID control
Input signal management: 0: Input valid
31
1: Override Input: open
2: Override Input: close
Display room temperature or set-point
32
0: Room temperature 1: Set-Point
Configuration external sensor
33
0: B = 3950; 1: B = 3450; 2: B = 3900
3: User define (via network. default B = 3950)
34-38
N/A
39
Start temperature of Low temperature protection
40
Stop temperature of Low temperature protection
It will confirm itself 20 seconds later after setting and return to Off state.
There is a 5 poles switch on PCB. The meaning is below:
Location
ON
1
120 ohm Resistance between AB wires
2
Port 1 Modulation 0 - 20mA
3
Port 1 Modulation 0 - 10VDC
4
Port 2 Modulation 0 - 20mA
5
Port 3 Modulation 0 - 10VDC
40
Stop temperature of Low temperature protection
1. Open the back panel with screwdriver.
3. Fix the base with screw.
0 - 255
0
0-2
0
0-1
0
0-3
5 °C/42 °F
0-15 °C/42-62 °F
7 °C/46 °F
2-17 °C/46-66 °F
OFF
No Resistance between AB wires
Off
Off
Off
Off
7 °C/46 °F
2. Connect the wires follow the diagram.
4. Fix the front panel and finish the installation.
AI097986404620en-010102 | 3
1 °C/2 °F
1 °C/2 °F