Danfoss VLT MCD 200 Istruzioni per l'installazione - Pagina 5

Sfoglia online o scarica il pdf Istruzioni per l'installazione per Unità di controllo Danfoss VLT MCD 200. Danfoss VLT MCD 200 5. Usb module
Anche per Danfoss VLT MCD 200: Manuale di istruzioni per l'installazione (17 pagine), Manuale di istruzioni per l'installazione (6 pagine)

MCD USB Module Instructions

5. Specifications

Order code

...................................................................................................................... 175G9009

Enclosure

Dimensions ............................................................. 35 mm (W) x 157 mm (H) x 90 mm (D)

Weight ...................................................................................................................... 250 g

Protection ................................................................................................................... IP20

Mounting

Spring-action plastic mounting clips (x 2)

Connections

Soft starter ........................................................................................... 6-way pin assembly

Network ................................................................................................................... USB-B

Maximum cable length ..................................................................... 3 metres (not supplied)

Settings

Protocol

MCD 200 ....................................................................................................... AP ASCII

MCD 500 ........................................................................................................... Binary

Address .......................................................................................................................... 20

Data rate (bps) ........................................................................................................... 9600

Symptom

"Unknown Device has been

detected" message when interface

is first plugged in

WinMaster goes offline and soft

starter trips on Starter Comms

WinMaster locks up when on-line.

Log view indicates comms failure

and a change to offline mode

Cause and solution

The USB cable may be too long.

Use a standard USB cable less than 3 metres long.

The USB cable has been unplugged.

Ensure the cable is plugged in at both ends, then bring

WinMaster back on-line.

Severe external electrical disturbance or equipment

failure.

Reconnect the USB cable, the close and restart

WinMaster. Bring WinMaster on-line.

If the problem persists, contact your local supplier.

MI.17.C1.02 – VLT

is a registered Danfoss trademark

Specifications