Danfoss PAHT G 256-308 Istruzioni - Pagina 8

Sfoglia online o scarica il pdf Istruzioni per Pompa dell'acqua Danfoss PAHT G 256-308. Danfoss PAHT G 256-308 20. Paht and paht g 256-308 disassembling and assembling

Stampa la pagina

Instruction

Disassembling and assembling PAHT and PAHT G 256-308

11. Retainer guide, retainer ball and

retainer plate must be mounted as

indicated in below picture.

13. Place retainer plate in cylinder barrel.

Note: If pistons are replaced, place new

pistons in clean filtered water for a

couple of minutes. Exercise piston shoes

to make them "run" smoother.

16. Place three bolts in mounting flange.

Turn each bolt one round at a time to

ensure mounting flange is mounted as

straight downwards as possible. Be careful

not to squeeze O-ring.

180R9268 / 521B1236 / DKCFN.PI.011.B3.02 / 01.2015

12. Ensure that retainer plate is oriented

correctly, i.e. with its slant surfaces

pointing downwards.

14. Place pistons in retainer plate and

cylinder barrel.

When pistons are placed, tilt retainer

plate for easier placement of swash plate.

If swash plate has been disassembled from

mounting flange, see page 10 for assembly

of swash plate.

15. Lubricate piston shoes and swash plate

with clean filtered water. Remember to

place the pins in housing.

Note: Screws for lifting eye are

shorter than the rest.

17. Screw in the rest of the bolts and cross

tighten all screws to a torque of

30 +/- 2 Nm.